659110

Tanita BCG-02 Manual

5
Zoom out
Zoom in
Previous page
1/24
Next page
5
en
Place the monitor on a hard, flat surface where there is minimal vibration to ensure safe and
accurate measurement.
Avoid excessive impact or vibration to the monitor.
Doing so may damage the monitor or cause it to malfunction, or may cause setting to be erased.
Do not use or store this monitor in the following locations.
·
Locations that are exposed to direct sunlight, near to heaters, or exposed directly to air
from air conditioning units, etc.
·
Locations where there are severe temperature changes or a large amount of vibration.
·
Locations with high levels of humidity or moisture.
Doing so may damage the monitor or cause it to malfunction.
Do not step on the monitor when your body is wet (immediately after a shower or bath, etc.)
Be sure to thoroughly dry your body and feet before using the monitor. Failure to do so may cause you to slip or fall,
resulting in injury. Also, the monitor cannot take accurate measurements if your body or feet are wet.
Keep away from water.
Do not use boiling water, benzene, thinner, etc. to clean the monitor.
If the monitor becomes dirty, soak a soft cloth in water or neutral household detergent,
wring it out thoroughly and wipe the monitor clean, then use a dry cloth to wipe the monitor dry.
Do not attempt to disassemble the monitor. Do not modify this equipment in any way.
Do not wash the monitor in water.
Do not submerge this monitor in water.
Doing so may damage the monitor or cause it to malfunction.
Be sure to insert the batteries with the polarities (+, -) in the correct position.
If the batteries are incorrectly inserted, battery fluid may leak and damage the floor.
(If you do not intend to use this monitor for a long period of time, it is advisable to remove
the batteries before storage.)
Do not use the monitor near other products such as microwave ovens that emit electromagnetic waves.
Doing so may cause the monitor to malfunction, preventing accurate measurements.
Another person should assist persons with disabilities who may not be able to take a measurement alone.
Always…
Getting Accurate Readings
To ensure accuracy, readings should be taken without clothing and under consistent conditions of hydration.
Always remove your socks or stockings, and be sure the soles of your feet are clean before stepping on the
measuring platform. Be sure that the arch of each foot is aligned with the center of the measuring platform.
Don’t worry if your feet appear too large for the unit, accurate readings can still be obtained if your toes
overhang the platform. It is best to take readings at the same time of day. Try to wait about two hours after
getting up, eating, or strenuous exercise before taking measurements. While readings taken under other
conditions may not have the same absolute values, they are accurate for determining the percentage change
as long as the readings are taken in a consistent manner. To monitor your progress, compare your weight and
body fat percentage readings taken under the same conditions over a period of time.
An accurate reading will not be possible if the soles of your feet are not clean, if your knees are bent or
if you are sitting down.
Note:
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tanita BCG-02 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tanita BCG-02 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info