19
How to Use
Commencing fat measurement
Press the ‘ ’ key.
1.Trunk % fat is displayed as .
(The moves as shown in the
diagram at right.)
2.The impedance meter buzzer sounds twice
when measurements are complete
(beep, beep).
Please do not move the impedance meter
or main unit until results have been
displayed (the impedance meter and main
unit transfer data).
9
18
How to Use
Preparing to take fat
measurements
1.Wet the area of the abdomen to which
electrodes will be attached.
2.Place the impedance meter across the
navel of the subject with the electrodes
facing down.
*The impedance meter can be oriented in
either direction.
3.The impedance meter detects the subject’s body and a buzzer will
sound
(beep).
4.Align the positioning line on the
impedance meter with the laser to
adjust the position.
8
*Blue print in display illustrations indicates parts that illuminate or flash.
Warning
Do not direct the laser directly towards
the eyes as this may cause damage to
eyesight.
Please…
To wet, wipe lightly with moistened cotton
wool or other cloth.
Please…
Check that the green Power LED is illuminated when positioning the impedance
meter.
* The impedance meter Power LED will automatically turn off when more than
approximately 10 minutes passes between the LED coming on and the impedance
meter being placed on the abdomen.
Please…
Do not connect together two or more units as this may cause malfunctions.
Have the subject breathe normally during measuring.
Check that the Power
LED is illuminated.
For Your Reference
Infrared communication may not be possible when:
•the unit is set up outdoors or in direct sunlight
•clothing or other items come between the main unit and the impedance meter
•lighting is positioned close by
•remote controllers for televisions, etc., are used near the impedance meter or main
unit
•the batteries have expired
Measuring
standard mode (cont’d)