517189
19
Zoom out
Zoom in
Previous page
1/25
Next page
8. INSPECTION AND MAINTENANCE BEFORE RIDING
19
CHECKING AND CHANGING FUSES
Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new one
having the same specified amperage rating (7A). Using a fuse of more than 7 amperes, a brass or iron
ire to replace a blown fuse is strictly prohibited to avoid damaging the electrical system and the circuit.
Remove the storage box, and you’ll find the fuse box near light.
Open the fuse box cover, and pull out the fuse. Check it for damage or broken.
Fuses must be firmly secured with wire connectors when replacing. Loose connections will result in
overhead and damage.
Use only parts having the specified specification to replace electrical components such as light bulbs.
Using parts not having the specified specifications for replacement may cause the fuse to blow and
over-discharge the battery.
Avoid spraying water directly on or around fuse box when washing the scooter.
Take your scooter to your dealer for an inspection if a fuse is blown by unknown causes.
REMOVE INSTALLATION
CHECKING THE SPARK PLUG
Remove the cap of spark plug cable (remove
the spark plug using the spark plug wrench in
the tool kit.
Check the electrode if it is dirty or fouled by
carbon deposits.
Remove the carbon deposits on the electrode
with steel wire, and clean the spark plug with
gasoline, then, wipe dry with a rag.
Check the electrode, and adjust its gap to
0.6~0.7 mm. (Check it with a feeler gauge)
Hand tight the spark plug as far as it can go
and then tighten it another 1/2~3/4 turns with
a wrench.
WARNING
The engine is very hot after running. Pay attention not to get burned.
Use only spark plugs suitable for the engine specifications of this scooter recommended by the
manufacturer. (Refer to specifications.)
CHECKING THE FRONT AND REAR LIGHTS
Start engine and turn on the head lamp switch. Check if head lamp and rear lamp come on.
Check the brightness and direction of front light by wall to see if it is correct.
Check the head lamp cover if it is dirty, crack, or loosen.
0.6~0.7 mm
Press in from above
Fuse connectors
Wire
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sym MIO 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sym MIO 100 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info