517186
18
Zoom out
Zoom in
Previous page
1/32
Next page
18
8. Important points and cautions for starting engine
CAUTION:
Please check the engine oil and fuel volume are adequate or not before starting engine.
To start engine the main parking stand must be firmly on the ground and the brake is applied on the
rear wheel to prevent the scooter from moving forward suddenly.
1. Turn ignition switch key to the “ON” position.
2. Apply hand (foot) rear wheel brake.
3. Do not accelerate, press starter button when the
brake is applied.
[We care for you! Before drive off, keep the hand (foot) brake applied on the rear wheel.]
CAUTION:
If engine can not be started after starter motor running for 3~5 seconds, turn the throttle valve handle
1/8~1/4 turns, and then press starter button again for an ease start.
In order to avoid damaging the starter motor, please do not press the starter button continuously over
15 seconds.
It is harder to get the engine started after the scooter has been left idle for a long time or after
refueling only after the fuel has been depleted. Then, it is necessary to press starting lever or starter
button several times, and keep the throttle valve handle at the close position to start the engine.
It may need several minutes to warm up engine if it is a cold start.
Exhaust contains harmful gases (CO), therefore please start the engine at a well ventilated place.
When starting engine with starting lever
Turn the main switch to ON, press the starting lever forcefully by foot with the throttle valve handle at
the close position.
If engine is difficult to start with the starting lever when the engine is cold, rotating the throttle valve
1/8~1/4 turns will make the start easier.
Put the starting lever back to its original position after the engine has been started.
CAUTION:
Firmly support the scooter with the main parking stand before starting the engine with the starting
lever.
Start engine with the starting lever occasionally to prevent it from loosing its function because of
unused for a long time.
1/4
1/8
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sym JET BASIX 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sym JET BASIX 50 in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info