673285
11
Zoom out
Zoom in
Previous page
1/31
Next page
10
7. Use of each component
USE OF BUTTONS
Engine Stop Switch
Switch to this position to turn off the engine when a state of emergency.
Switch to this position and the engine can be started.
Electrical Starter Button
This is a starting motor button (switch) for engine starting. With the main switch “ON”, press this
button while holding the front or rear brake lever will start the engine.
CAUTION:
Release this button immediately after engine has been started, and never press the button again
to avoid damaging the engine.
This mechanism is a safety design. The engine can only be started after the front or rear brake
lever has been applied.
Do not use light system. Turn headlight and turn signal lights to the “OFF” position when the
engine is being started.
If the side stand is put down, the engine will stop immediately.
Retrieve the side stand before starting the engine.
Automatic Lighting Connections Turn main switch on “ON” , at the same time, the electrical connections
of lights will be connected automatically, including position lightlow beam headlightsrear position lamp
and rear-registration plate illuminating cannot be switched “ON” or OFF” otherwise than simultaneously.
Hazard Warning Switch
With the ignition switch in theONposition, this hazard switch with triangular symbol can be
operated. When this button is pushed, all four indicators (front and rear-right and left) begin to blink
simultaneously, and direction indicators on the instrument panel also flash.
When you are experiencing a sudden vehicle problem in the middle of traffic or the vehicle has broken
down, switch on the lights and slowly pull over, keep the lights flashing till the problem is solved. Pressing
the hazard switch again cancels this feature. The hazard lights only can be switched off when the main
switch is in theONposition.
High/Low Beam Switch This is the high and low beam of headlight master switch. Press this switch
to swift between high and low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
CAUTION:
Automatic Lighting Connections are powered by battery, and therefore be aware of keeping main
switch on “ON” will run out of the battery without running the engine.
Electrical
Starter Button
High/Low Beam Switch
Turn Signal Switch
Horn Switch
Engine Stop Switch
Pass switch
Seat Open Switch
Hazard Warning
Switch
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sym CRUISYM - LV30-25W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sym CRUISYM - LV30-25W in the language / languages: English as an attachment in your email.

The manual is 8,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info