WARNING:
TO EXPOSE THIS
ANCE T
IMPOR
CAUTION: TO REDUCE
SHOCK, DO NOT REMOVE COVER (OR BACK) NO
USER SER
VICING TO QUALIFIED SER
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THIS SYMBOL INDICA
GEROUS VOL
RISK OF ELECTRIC SHOCK IS PRE-
SENT WITHIN THIS UNIT
THIS SYMBOL INDICA
THERE ARE OPERA
AND MAINTENANCE INSTRUCTIONS
IN THE LITERA
THE APPLIANCE.
The important note is located on the rear of the cabinet.
1. Read instructions-All the safety and operating instruc-
tions should be read before the appliance is operated.
2. Retain Instructions-The safety and operating instruc-
tions should be retained for future reference.
3. Heed W
the operating instructions should be adhered to.
4. Follow Instructions-All operating and use instructions
should be followed.
5. Cleaning-Unplug TV from the wall outlet before clean-
ing. Do not use liquid cleaners or aerosol cleaners. Use
a damp cloth for cleaning.
EXCEPTION: A product that is meant for uninterrupt-
ed service and, that for some specific reason, such as
the possibility of the loss of an authorization code for a
CA
the user for cleaning or any other purpose, may
exclude the reference to unplugging the appliance in
the cleaning description otherwise required in item 5.
6. Attachments-Do not use attachments not recommended
by the TV manufacturer as they may cause hazards.
7. W
example, near a bath tub, wash bowl, kitchen sink, or
laundry tub, in a wet basement, or near a swimming
pool, and the like.
8. Accessories-Do not place this TV on an unstable cart,
stand, tripod, bracket, or table. The TV may fall, caus-
ing serious injury to someone, and serious damage to
the appliance. Use only with a cart, stand, tripod,
bracket, or table recommended by the manufacturer
sold with the TV
Any mounting of the appliance should follow the man-
ufacturer
use a mounting accessory recom-
mended by the manufacturer
appliance and cart combination
should be moved with care. Quick
stops, excessive force, and uneven
surfaces may cause the appliance
and cart combination to overturn.
AMEUBLES- Cet appareil ne doit être placé que sur un
meuble (avec ou sans roulettes) recommandé par le
fabricant. Si vous l’installez sur
un meuble à roulettes, déplacez
les deux ensembles avec précau-
tion. Un arrêt brusque, l’utilisation
d’une force excessive et des sur-
faces irrégulières risquent de
déstabiliser l’ensemble et de le
renverser
9. V
back or bottom are provided for ventilation and to
ensure reliable operation of the TV and to protect it
from overheating, these openings must not be blocked
or covered. The openings should never be blocked by
placing the TV on a bed, sofa, rug, or other similar sur-
face. This TV should never be placed near or over a
radiator or heat register should not be placed
in a built-in installation such as a bookcase or rack
unless proper ventilation is provided or the manufac-
turer
10. Power Sources-This TV should be operated only from
the type of power source indicated on the marking
label. If you are not sure of the type of power supply to
your home, consult your appliance dealer or local
power company
tery power
instructions.
11Grounding or Polarization-This
polarized alternating-current line plug(a plug having
one blade wider than the other). This plug will fit into
the power outlet only one way
If you are unable to insert the plug fully into the outlet,
try reversing the plug. If the plug should still fail to fit,
contact your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the polarized plug.
PORTABLE CART WARNING
S3126A
12. Power-Cord Protection-Power-supply cords should be
routed so that they are not likely to be walked on or
pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience
receptacles, and the point where they exit from the
appliance.
13. Outdoor Antenna grounding-If an outside antenna or
cable system is connected to the TV
na or cable system is grounded so as to provide some
protection against voltage surges and built-up static
charges.
ANSI/NFP No. 70, provides information with respect
to proper grounding of the mast and supporting struc-
ture, grounding of the lead-in wire to an antenna dis-
charge unit, size of grounding conductors, location of
antenna-discharge unit, connection to grounding elec-
trodes, and requirements for the grounding electrode.
(Fig. A)
14. Lightning-For added protection for this TV receiver
during a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it from the
wall outlet and disconnect the antenna or cable system.
This will prevent damage to the TV due to lightning
and power-line sur
15. Power Lines-An outside antenna system should not be
located in the vicinity of overhead power lines or other
electric light of power circuits, or where it can fall into
such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep
from touching such power lines or circuits as contact
with them might be fatal.
16. Overloading-Do not overload wall outlets and extension
cords as this can result in a risk of fire or electric shock.
17. Object and Liquid Entry-Never push objects of any
kind into this TV through openings as they may touch
dangerous voltage points or short out parts that could
result in a fire or electric shock. Never spill liquid of
any kind on the TV
18. Servicing-Do not attempt to service this TV yourself as
opening or removing covers may expose you to dan-
gerous voltage or other hazards. Refer all servicing to
qualified service personnel.
19. Damage Requiring Service-Unplug this TV from the
wall outlet and refer servicing to qualified service per-
sonnel under the following conditions:
a. When the power supply cord or plug is damaged or
frayed.
b. If liquid has been spilled, or objects have fallen into
the TV
c. If the TV has been exposed to rain or water
d. If the TV does not operate normally by following the
operating instructions.
are covered by the operating instructions, as improper
adjustment of other controls may result in damage and
will often require extensive work by a qualified techni-
cian to restore the TV to its normal operation.
e. If the TV has been dropped or damaged in any way
f. When the TV exhibits a distinct change in perfor-
mance-this indicates a need for service.
20. Replacement Parts-When replacement parts are
required, be sure the service technician uses replace-
ment parts specified by the manufacturer that have the
same characteristics as the original part. Unauthorized
substitutions may result in fire, electric shock, injury to
persons or other hazards.
21. Safety Check-Upon completion of any service or
repairs to this TV
routine safety checks to determine that the TV is in
proper operating condition.
22. Heat-This TV product should be situated away from
heat sources such as radiators, heat registers, stoves, or
other products (including amplifiers) that produce heat.
FIGURE A
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
ELECTRIC
SERVICE
EQUIPMENT
GROUND
CLAMP
NEC - NA POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC AR
S2898A
GROUND CLAMPS
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
ANTENNA
LEAD IN
WIRE
OPERA
1. VIDEO (INPUT) jack- Connect to the
video output jack of a video camera, VCR,
or video game.
2.
AUDIO L/R (INPUT) jacks- Connect to
the left/right channel audio output jacks of a
video camera, VCR, or video game.
Note: The
mono input. The sound is heard from both
speakers. Use this jack for connecting
monaural audio equipment.
3.
MENU button- Press to display the menu
on the TV screen.
4.
VOLUME (V▲/ ▼ buttons- Press to
control the volume level.
Press to determine the setting mode from the
menu on the TV screen (only the VOL ▲
button).
Press to select or adjust from a particular
menu (for example: Language Selection,
Channel Presetting, Closed Caption Selec-
tion, Picture Set Up).
5.
CHANNEL (CH) ▲/ ▼ buttons- Press to
select memorized channel.
Press to select the setting mode from the
menu on the TV screen.
Press to select item you want to adjust in
the picture control mode.
6.
POWER button- Press to turn the TV ON
and OFF
7.
Infrared Sensor W- Receives the
infrared control signals from the remote
control.
8.
Channel number buttons- Press two digits
to directly access the desired channel.
Remember to press a “0” before a single
digit channel.
+100 button- Press to select cable channels
higher than 99.
9.
MUTE button- Press to turn off the sound
portion of the TV program (V
display turns LIGHT RED from LIGHT
BLUE). Press this button again or press the
VOL(ume) ▲ or ▼ button to restore sound.
10.
INPUT SELECT button- Press to select
TV or the external input (VIDEO1,
VIDEO2, VIDEO3 or COMPONENT) (See
USING AUDIO/VIDEO
11
CH RETURN button- Press to go back to
the previously viewed channel. For exam-
ple, pressing this button once will change
channel display from CH 3 (present chan-
nel) to CH 10 (previously viewed channel)
and pressing it a second time will return
from CH 10 to CH 3.
12.
DISPLA- Press to display the
channel number on the screen. If you press
it again, the channel number will disappear
13.SLEEP button- Press to display the sleep
timer and begin the timer
can be set by the number of times you press
the button (0, 10, 20, 30,..90, 0 minutes).
14.
AC cord- Connect to a standard
(120V/60Hz).
Note: Unwrap the
from the back cover before plugging the
cord into an
15.AUDIO L/R OUTPUT jacks- Connect to
the left/right channel audio input jacks of a
home stereo system.
16.
S-VIDEO input jack- Connect to the
S-VIDEO output jack of a video camera,
VCR or video game system using the
S-VIDEO cable (not supplied).
Note: The S-VIDEO jack is given priority
over the VIDEO (Rear) jack.
17.
COMPONENT AUDIO input jacks-
Connect to the left/right channel audio out-
put jacks of DVD player when using the
COMPONENT VIDEO INPUT jacks.
18.ANT(enna). IN jack- Connect to an anten-
na, cable system or satellite system.
19.COMPONENT VIDEO INPUT jacks -
Connect to the Component V
jacks of DVD player
Note: This TV can only accept a 480i
(interlaced) video signal.
- REMOTE CONTROL -
VIDEO
L - AUDIO - R
MENU VOLUME CHANNEL POWER
45
67
12 3
AUDIO OUTPUT
L
R
L
R
L
R
Pb
Y
Pr
VIDEO 3 INPUT
VIDEO
S-VIDEO
AUDIO
ANT
COMPONENT VIDEO-INPUT
VIDEO 1 INPUT
POWER
INPUT
SELECT
DISPLA SLEEP
MUTE CH RETURN
VOL
12
45
78
MENU
0
+100
CH
TV
6
8
4
3
9
12
11
13
10
5
INST
1) Remove the battery
compartment cover on the
remote unit by sliding it while
slightly twisting.
2) Insert 2 “AA” penlight
batteries into battery
compartment in the direction
as indicated by the polarity
(+ /
-
) markings.
3) Replace the cover
4) Push the cover on it’
until it clicks in order to fit the
cover completely to the
compartment.
USING AUDIO/VIDEO JACKS
When you use the
or COMPONENT VIDEO INPUT jacks, select
“VIDEO1”, “VIDEO2”, “VIDEO3” or “COM-
PONENT” mode by pressing the INPUT
SELECT button on the remote control.
•To select the VIDEO1 INPUT jacks on the
rear of the TV
•To select the jacks on the front of the TV
select “VIDEO2”.
•To select the VIDEO3 INPUT jacks on the
rear of the TV
•To select the COMPONENT VIDEO INPUT
jacks on the rear of the TV
NENT”.
Note: When you use the S-VIDEO connec-
tion, S-VIDEO jack is given priority over the
VIDEO jack on the rear panel.
SYMBOLE D'AVERTISSEMENT POUR
LES COMPOSANTES
APPAREIL ET MEUBLE A ROULETTES
S3126A
- FRONT P -
- REAR P -
