CONNECTION
[ANTENNA / BASIC CABLE CONNECTION]
When connecting TV to antenna *For digital signal
1) Connect the RF cable or antenna cable on your home outlet to the ANT. IN jack of this TV.
When connecting
TV to basic cable (without box) *For analog reception only
1) Connect the RF cable or incoming cable on your home outlet to the ANT. IN jack of this TV.
*Once connections are completed, turn on the TV and begin initial setup.
Channel scanning is necessary for the TV to memorize all available channels in your area if using antenna or
basic cable. (Refer to "INITIAL AUTO PRESET" on page 13.)
NOTES:
• For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. IN jack before moving the unit.
• If you use an antenna in order to receive analog TV, the same antenna generally will work for DTV reception.
Outdoor or attic antennas will be more effective than set-top versions.
• Some cable channels cannot be viewed when the TV is connected to an aerial antenna because DTV program does not cover all
cable channels. You can watch them by switching to the cable connected to CATV.
• To easily swith between antenna and cable wires, you can purchase “Antenna Selector” commercially available.
MAKE SURE YOU HAVE AN ANTENNA
As DTV is only available over the air, you need an antenna to receive digital signal.
A
DDITIONAL SHEET FOR 6427GFF
You are kindly requested to read the additional instruction below.
1EMN20829 Printed in Malaysia
L3820UA
★★★★★