11615
23
Zoom out
Zoom in
Previous page
1/45
Next page
OTR (One Touch Recording)
This function enables you to set a recording length simply
by pressing the REC/OTR button on the TV/VCR.
Make sure ...
TV/VCR power must be turned on.
Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTES:
This function CANNOT be done from the remote control.
Recording starts immediately when the REC/OTR
button is pressed.
When the REC/OTR button is pressed 18 times, the
TV/VCR returns to the Normal Recording mode.
To stop the OTR operation, press the STOP button
on the TV/VCR or on the remote control.
To show the remaining time, press the DISPLAY button
on the remote control so that "OTR" appears on the TV
screen. (It will show up momentarily then disappear.)
Recording stops when 0:00 is reached.
Please note that in the SLP mode maximum recording
time, assuming the tape is started at the beginning,
is 8 hours using T-160 (or 6 hours using T-120).
If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, ejects the
tape and turns itself off.
1 Select the channel to be recorded
Press the number buttons on the remote control or the
CHANNEL
or
button.
Remember:
If the TV/VCR is connected to a cable box
or satellite box, the TV/VCR must be on CH3 or CH4,
then the channel to be recorded is selected on the cable
box or satellite box.
2
Begin OTR
Press the REC/OTR button on the
TV/VCR as many times as needed. The
recording length will be determined by
the number of times you press the
REC/OTR button. Each additional push will increase
the recording time by 30 minutes. It is set up to 8 hours.
Push(es) Display Recording length
1 push (normal recording)
2 pushes 0:30 30 minutes
3 pushes 1:00 60 minutes
↓↓
17 pushes 8:00 480 minutes
COPYING A VIDEO CASSETTE
(Requires a VCR or video camera)
You can make copies of video tapes made by friends or
relatives for your enjoyment.
WARNING: Unauthorized recordings of
copyrighted video tapes may be an
infringement of copyright laws.
Connect your TV/VCR and a Source (Playing) VCR
using the following diagram.
1) Insert a pre-recorded video cassette into the Source
(Playing) VCR or video camera.
2) Insert a blank video cassette, or one you want to record
over, into the TV/VCR’s cassette compartment.
3) Press the SPEED button on remote control for the
TV/VCR to select the desired recording speed
(SP/LP/SLP).
4) Press the CHANNEL
or
button on the TV/VCR
until "AUX" appears on the screen.
5) Press the RECORD button on the TV/VCR.
6) Begin playback of the tape in the source (Playing)
VCR or video camera.
NOTE
: For best results during dubbing, use the
TV/VCR’s front panel controls whenever possible. The
remote control might affect the source (Playing) VCR’s
playback operation.
OTR ( 2 : 3 0 )
SP
AUIO
EARPHONE
IEO
IEO
IN
OUT
AUIO
Audio/Video
adapter cable
(not supplied)
[Ex: Source (Playing)
VCR or video camera]
[The TV/VCR]
[Fig.8]
7L26
B7916-03
- 23 - EN
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sylvania 3819LC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sylvania 3819LC in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info