687769

Switel BCC48 Manual

37
Zoom out
Zoom in
Previous page
1/44
Next page
− Operation −
37
4 Operation
Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby’s room
through the Parent Unit. You should also be able to "see" those sounds as the green and red sensor
lights around the top of the Parent Unit rise and fall with the sound levels.
If the connection between the Parent and Baby Units is broken at any time the green Link light
on the Parent Unit will flash slowly, the parent unit will beep to alter you that the link has been
lost and the green and red sensor lights will cease to react to any sounds. To re−establish the
Link, move closer to the baby unit or follow the directions in chapter "Troubleshooting".
Switching your Baby Monitor On or Off
Once connected to the power supply, your Baby unit and Parent Unit must both be switched on to
operate. To switch on, press and release the Power Key" on each Unit. To switch off, press and hold
the Power Key".
Volume
You can adjust the volume at which you hear your baby by using the Up" and Down" keys on the
side of the Parent Unit. Whilst you are adjusting the volume, the 5 green sound sensor lights act as an
indicator of the volume level.
Battery Level Indicator/Battery Low Warning
The Parent Unit will work up to 10 hours out of the Charger Pod, but this depends on the level of
charge in the batteries. If the charge is low, the red Power light on the Parent Unit will begin to flash
and you should return it to the Charger Pod to recharge the batteries. You can still use your Parent
Unit from the Charger Pod.
When you first switch on your Parent Unit, the green and red sensor lights will briefly indicate the
current charge level of the batteries in the following way:
8 lights illuminated = fully charged
6 lights illuminated = half charged
4 lights illuminated = battery is running low
2 lights (alarm beep sounds) = batteries need re−charging
A battery low warning beep will sound if the charge is low, or becomes low during use and the red
power light on the Parent Unit will begin to flash. If this occurs you should return the Parent Unit to the
Charge Pod to re−charge the batteries. You can still use your Parent Unit from the Charge Pod whilst
the batteries are charging.
Baby Alert
If the volume of your Parent Unit is turned all the way down and you are just using the lights to
monitor the noise levels in your baby’s room, you will hear a warning beep on the Parent Unit should
the noise levels in your baby’s room increase to the point that the red sound sensor lights are
showing. To stop the alert tone and turn off the Baby Alert feature, just turn the volume back up at the
Parent Unit.
Parent to Parent Paging
Useful if one parent is in the baby’s room and needs contact the other. Also helps to find a mislaid
Parent Unit.
At the Baby Unit
Press and hold the "Page key ". The Parent Unit will emit a paging tone. To cancel the tone either
press and hold any key on the Parent Unit, or press the "Page key on the Baby Unit a second time.
Night Light
The Baby Unit has a one touch night light which emits a soft starry glow, providing comfort and
re−assurance for your baby and allowing you to see them in a darkened room.
At the Baby Unit
Press the "Night Light Key" on the top of the unit. A soft light will turn on gently. Press again and the
light will fade away.
… 37 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Switel BCC48 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Switel BCC48 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info