Fig 12
Fig 13
Fig 14
Fig 11
5. STOPPING THE GENERATOR ENGINE
Before stopping the engine, switch off all the electrical
loads and turn the generator ON/OFF switch to the
OFF position (See fig 11).
Before stopping the engine make sure that all the
electrical loads are disconnected from the generator AC
outlet socket.
When the generator engine has stopped and before
storage, turn the fuel cock lever to the OFF position as
shown in Fig 12.
6. CONNECTING THE ELECTRICAL
LOAD
Warning! Before connecting any electrical load to the
generator ensure that the load does not exceed the
maximum load as stated on the rating plate. Ensure that
the mains supply lead is long enough to reach the
generator without any strain.
When the generator engine has been successfully
started and is running smoothly connect the electrical
load into the generator AC output socket (See fig 13).
7. OVER LOAD PROTECTION
The generator is fitted with an overload protection
device located on the control panel (See fig 14). In the
event that the load exceeds that stated on the rating
plate, the overload protection will operate and
disconnect the load. If the overload protection device is
tripped. Check the electrical load and if necessary
reduce the load.The overload protection device can be
re-set by pressing in the re-set button.
