628330
8
Zoom out
Zoom in
Previous page
1/16
Next page
Pagina 8
Descrizione componenti
Rif. disegno 1 pagina 7
A.
Manopola lancia vapore: girare a sinistra per aprire a destra per
chiudere. Non toccare il retro della manopola: pericolo di ustione!
B.
Lancia vapore. Non toccare le parti metalliche non isolate: pericolo
di ustione!
C.
Manometro caldaia: indica la pressione in caldaia.
D.
Interruttore accensione/spegnimento: pos. 0 = spento ; pos. 1 = ac-
ceso
E.
Spia controllo macchina. Durante l’uso della macchina e’ accesa, se
lampeggia controllare il livello dell’acqua nel serbatoio
F.
Gruppo di erogazione: Elevato rischio di ustione! Diventa caldo a
macchina accesa.
G.
Portafiltro: le parti metalliche diventano molto calde a macchina ac-
cesa
H.
Pistone infusore del gruppo: scarica l’acqua bollente nella bacinella
ad erogazione finita. Elevato rischio di ustione con acqua bollente e par-
ti metalliche!
I.
Leva erogazione: Non toccare le parti metalliche non isolate: perico-
lo di ustione!
J.
Manopola lancia acqua calda: girare a sinistra per aprire a destra
per chiudere. Non toccare il retro della manopola: pericolo di ustione!
K.
Lancia acqua calda. Non toccare le parti metalliche non isolate: pe-
ricolo di ustione!
L.
Bacinella di scarico e griglia: Attenzione : svuotare periodicamente
Bacinella scaldatazze: non versare liquidi! Pericolo di scossa elettrica
dovuta al contatto dei liquidi con l’interno della macchina.
Pagina 25
Start up
Before starting using the machine, please check the following:
Lever (Dr.1- I) is completely down.
Steam handle (Dr.1 - A) is closed.
Hot water handle (Dr.1 - J) is closed.
On/off switch (Dr.1 –D) is on position “0” (=machine switched off)
Machine is unplugged.
Drip tray (Dr. 1-L) and its grid are properly positioned into the ma-
chine.
Now please proceed as follows:
Remove the cover from the machine’s cups tray on top (Dr.1- M).
Remove the water reservoir and clean it carefully with food quality
cleaning products. It’s very important that the water reservoir is
always clean! Please repeat this operation every day and when-
ever necessary.
Fill the water tank with fresh drinking water to just over ¾ full.
Place the tank inside the machine taking care not to spill water.
Put on the cover on top of the water reservoir.
Note: It may be possible that during removal and replacing of the tank
some air remains in the collector put on the end of the tank. In this case
the control lamp flashes although the tank is filled in. Please remove
and replace partially the tank in order to get the air out from the collec-
tor.
Plug in the machine.
Turn the on/off switch (Dr.1 – D) to the on position “1” (= machine
switched on) and open the steam handle (Dr. 1-A) by turning left
side. Boiler water fill starts (you will hear the pump’s noise).
When the boiler is properly filled with water, the pump will stop
(=no more noise). Now close the steam handle (Dr. 1- A) by turn-
ing right side.
The heating up of the boiler water starts.
Wait till the boiler pressure gauge (Dr.1 – C) reads approximately
1 bar.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SV Italia SAB Sabina at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SV Italia SAB Sabina in the language / languages: English, Italian as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info