Manual Suntec Klimatronic FUSION plus 12.000 (page 19 of 152) (All languages)

664809

Zoom out

Zoom in

1/152

Water drainage

1.Manual drainage :

1.1 When water tank is full and unit stop working, please shut off the unit and unplug

Please don’t move the model sharply, or the water will spilt out from water received plate.

1.2 Use a water container to take water under the water plug.

1.3 Screw off the water plug and unplug the water blocker, water will come out to the water container.

2. Continue drainage:

2.1 Screw off the water plug and unplug the water blocker.

2.2 Use water pipe to connect the water outlet. Lead the pipe to the outside or washroom.

Remark: 1.This method can be done only if there is no water in the water received plate.

2.3This model have self evaporative function, under cooling mode, please don’t use continue drainage to get

better cooling effect.

Cleaning

Please shut off the unit and unplug the plug before cleaning or maintenance

Clean the surface

Clean the housing with a duster or a soft wet cloth. Do not use chemical

solvent (such as benzene, alcohol, gasoline). The surface may be

damaged or even the whole case may be deformed.

1. Air filter cleaning

1.1Clean the air filters every 2 weeks. If the air filter is blocked with dust,

the efficiency will reduce.

1) Pull out up and down filter as below pictures

2) Wash the air filters by immersing it gently into warm (about 40℃) water

with a neutral detergent, rinse it and dry it thoroughly in a shaded place。

3) Install air filters carefully after cleaning the filters.

Storage

1. Pull out the plug in drainage hole and empty the water-received plate, or drain out the water by leaning the unit,

then shift the unit mode to Fan mode, and press the button for 5 seconds till it to low fan speed. Keep this mode for

half day till the conduit is dried. Doing like this can keep the inner unit dried and not go moldy.

2. Turn off the unit and pull out the plug.

3. Coil the wire and bind it together, then put it into the accessories room.

4. Separate the air-exhausted pipe and safely keep it.

5. Put the unit into a plastic bag, then keep it in a dried place.

6. Take out the batteries of remote control and safely keep them.

Trouble Shooting

Don’t repair or disassemble the unit by yourself, unsuitable repair may make the quality-protected card in vain,

and even cause damage to the user or his/her possession.

Trouble

Reason

Solution

The unit doesn’t

work

No power supply

Power-on and turn on the unit.

Water-full indicator illuminate

Drain out the inner stored water

Timer function is active

Cancel Timer function

Room temperature too low or too

high?

Suggesting ambient temperature between 7-40℃

The unit does not

seem to perform.

In direct sunlight

Draw the curtains

Windows or doors open, many

people or a heat source in the room

Close windows and turn on another local air

conditioner

Filter is very dirty

Clean or change the air filter

Air inlet or air outlet is blocked

Clear out the stemming

Room temperature is lower than

setting temperature

Change the setting temperature

The unit noise is

high

The unit is not put on flat place

Put the unit on flat and hard place( reduce noise)

Compressor

doesn’t work

Heat-exceeded protection is

active

Re-start the unit 3 minutes later till the temperature

low down.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Suntec Klimatronic FUSION plus 12.000 in the language / languages: All languages as an attachment in your email.

The manual is 2,16 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Suntec Klimatronic FUSION plus 12.000 Manual

Product: