767637

Suntec Klimatronic FRESH 9.000 Eco Manual

17
Zoom out
Zoom in
Previous page
1/158
Next page
Frost protection
• In cooling, dehumidifying and sleeping modes, the unit has an automatic frost protection function
designed to protect the unit at low temperatures. The device also has an automatic defrosting function.
Emptying of the water tank
• As soon as the water tank is full, the “WF” blinks on the display, the
standby mode automatically turns on, it will sound the warning alarm and
all the buttons will be locked until the tank is emptied.
• Turn off the power and unplug the power cord. To empty of the water tank
you need to remove the rubber stopper on the bottom of the unit and let
the water leak into a container. Once you reboot the device, it will work
normally.
• Continuous drainage (only in dehumidifying mode): Remove the rubber
stopper on the bottom of the unit and connect the drainage hose to the
opening. Let the water leak into a container (pic.5).
Pic.5
Cleaning
• Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
• Wipe over the exterior of the appliance with a soft wet cloth and neutral detergent and then wipe dry
with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
• Clean the dust filter once every two weeks. Clean the dust filter
with neutral detergent and about 40°C water. Rinse off any
detergent, then let it air-dry before inserting it back into the unit
(pic.6).
• If you do not use the unit for a longer time, empty the water tank
completely. Make sure that the unit is disconnected from the
power supply and that it is clean. Keep the unit covered in a dry
place.
Pic.6
Troubleshooting
Problem
Possible causes
Suggestions
1. Unit does not start
when pressing
“POWER”.
Water tank is full and indicating light
“W.F.” is blinking.
Empty the water tank.
Room temperature is lower than the set
temperature during operation mode
cooling.
Reset the temperature.
The ambient temperature is too low or
too high.
We recommend the operaiton at 7-35°C.
In dehumidification mode, the ambient
temperature is too low.
The ambient temperature needs to be
higher than 17°C.
2. It’s not cool
enough.
Doors or windows are not closed.
Close all doors and windows.
There are heat sources in the room.
Remove the heat sources if possible.
Exhaust hose is not installed or blocked.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Set temperature is too high.
Reset the temperature.
Air inlet is blocked.
Clean the air inlet
3. Unit is too loud.
The ground is not even and flat enough
Place the unit on an even and flat surface.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Suntec Klimatronic FRESH 9.000 Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Suntec Klimatronic FRESH 9.000 Eco in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info