Emptying of the water tank
• As soon as the water tank is full, the “WF” blinks on the display,
the standby mode automatically turns on, it will sound the
warning alarm and all the buttons will be locked until the tank is
emptied.
• Turn off the power and unplug the power cord. To empty of the
water tank you need to remove the rubber stopper on the
bottom of the unit and let the water leak into a container. Once
you reboot the device, it will work normally.
• Continuous drainage (only in dehumidifying mode): Remove
the rubber stopper on the bottom of the unit and connect the
drainage hose to the opening. Let the water leak into a
container (pic.5).
Pic.5
Cleaning
• Always disconnect the appliance from the power outlet and
let it cool before cleaning. Never immerse the appliance in
water to prevent electric shocks.
• Wipe over the exterior of the appliance with a soft wet cloth
and neutral detergent and then wipe dry with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
• Clean the dust filter once every two weeks. Clean the dust
filter with neutral detergent and about 40°C water. Rinse off
any detergent, then let it air-dry before inserting it back into
the unit (pic.6).
• If you do not use the unit for a longer time, empty the water
tank completely. Make sure that the unit is disconnected
from the power supply and that it is clean. Keep the unit
covered in a dry place.
Pic.6
Troubleshooting