622354

Sunrise Medical Quicky Classic 100 Manual

7
Zoom out
Zoom in
Previous page
1/64
Next page
CLASSIC 100, 160, 160XL 7
ENGLISH
One Hand Wheel Locks
Your wheelchair is equipped with
two sets of wheel locks, that ope-
rate from the left or the right side.
They are applied directly against
the tyres. To engage, press the
wheel-lock lever forward against
the stop (fig. 1). To release the
wheel, pull the lever back to the
original position.
Holding power will decrease with:
• Worn tyre tread
• Tyre pressure that is too low
• Wet tyres
• Improperly adjusted wheel locks.
The wheel locks have not been
designed to be used as brakes for
a moving wheelchair. The wheel
locks should therefore never be
used to brake a moving
wheelchair. Always use the hand-
rims for braking. Make sure that
the interval between the tyres and
wheel locks complies with given
specifications. To readjust, loosen
screw and set the appropriate interval.
Tighten screw (see the page on torque).
CAUTION:
After each adjustment of the rear wheels, check
the interval to the wheel locks and readjust if
necessary.
Mounting the wheel lock too close toward the
wheel, will result in a higher effort to operate.
This might cause the brake lever extension to
break! Leaning on to the brake lever extension
while transfering will cause the lever to break!
Splashing water from tyres might cause the
wheel lock to malfunction.
Footplates
The footplates can be flipped up to
facilitate getting in and getting out
of your wheelchair.
Lower Leg Length
By removing the screws (1), the
legrest can be adjusted to fit any
lower leg length. Loosen the
screws, set the tubing with legrest
in the desired position, and then
tighten the screws. (See the page
on torque).
A minimum interval of 2.5 centimetres from the
ground should always be maintained.
Options – Footplates
1
2,5 cm
Legrests and Latch
The legrest can be swung in,
underneath the seat sling, or out-
wards.
Fit your legrest by inserting it with
the footplate(s) pointing toward the
in/outside. Then rotate it toward
the inside until it locks into place.
To remove the legrest, pull the
lever (1), swing the footrest towards
the in or outside and lift to remove
it. Make sure that the legrest is
properly locked into place.
CAUTION:
The legrests should not be used to lift or to carry
the wheelchair.
1
Flip-up footrest (standard or with length
adjustment):
To elevate:
Pull the footrest upwards and adjust it to the desired
height. You will hear the footrest click into place.
To lower:
Lift the lower leg and press the release lever to
unlock the footrest. You may now lower the footrest.
As soon as you let go of the lever, the footrest will
lock into place.
CAUTION:
Keep hands clear of the adjustment mechanism
between the frame and the movable parts of the
footrest while elevating or lowering the footrest.
CAUTION:
Footrests are not to be used for lifting or carry-
ing the wheelchair.
Stump pad
The stump pad can be adjusted in all directions to
fit the users need.
1009/3/ST-000690634.EMS.2/Rev.D
Castors, Castor Plates, Forks
From time to time the wheelchair may veer slightly
to the right or left, or the castors may flutter. This
may be caused by the following:
• Forward and/or reverse wheel motion has not
been set properly.
• The castor angle has not been adjusted properly.
• Castor and/or rear wheel air pressure is incorrect;
wheels do not turn smoothly.
The wheelchair will not move in a straight line if the
castors have not been properly adjusted. Castors
should always be adjusted by an authorized dealer.
The castor plates must be readjusted, and the
wheel locks must be checked any time the rear
wheel position has been altered.
Options – Castor
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sunrise Medical Quicky Classic 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sunrise Medical Quicky Classic 100 in the language / languages: English, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info