721430

SunRed WMC1800R Manual

4
Zoom out
Zoom in
Previous page
1/14
Next page
www.sunred.nl
Operations
1.
Plug in the unit to a socket. Make sure the power
the blue indicator li
ght is flashing, which means it's in standby status.
2.
Press button "On" on the control panel or the remote controller to switch on the heater.
3.
To switch off the heater, press the button "Off" on the control panel of the heater. When press the "Off" button on the contr
panel of the heater, the blue indicator light is off, and the remotrol is unfunctional. To press "Off" button
will only swift the appliance into standby status, and the blue indicator light is flashing.
Cautions
1.
The unit must be placed with the clearance of 100cm to the wall and 30cm to the ceiling .
2.
The heater must be installed at least 1,8m above the floor.
3.
The unit must be securely placed on a horizontal and flat surface.
4.
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur whe
touching it during this period.
5.
Don't place the unit close to curtain and/or other flammable objects.
6.
Dont' cover the unit with anything during operation or a short time after it's shut down.
7. Don't wrap t
he power supply cord on the unit.
8.
The unit must be handled with care, and avoid of vibration or hitting.
9.
The unit must be securely grounded during operation.
10.
When damaged, the unit must be repaired by professional reparing team.
11. If the supply cord is damag
ed, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
12.
The heater must not be located immediately below a socket
13.
When assembling, keep clear from any board or flammable material.
14. Do
not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly.
15.
This appliance is not intended for use by persons (including children)
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
16. Children should be supervised to e
nsure that they do not play with the appliance.
17.
The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flamm
dust.
18.
The head of the unit is at high temperature during operation. Unplug th
19.
Don't use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
20.
Don't use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
21. Don't use this un
it as a cloth drier or towel drier.
22. Dont' use this unit as a sauna heater.
23.
Don't use this unit as a room heater of heat storing.
24.
Don't use this unit in place of animal propagating and raising.
25.
Don't use this unit in heating system of hot air centre.
26.
Don't immerse this unit into water for cleaning.
27.
The unit should be plugged in a socket, which is easily visible and reachable.
28.
Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
th
e first few minutes after it's turned on. This is normal, and may not affect the performance of the unit
Cleaning
Unplug the unit before cleaning. It should be wiped with wet cloth. Don't use too much water.
www.sunred.nl
Plug in the unit to a socket. Make sure the power
supply is same as rated. When press the "On" button on the control panel,
ght is flashing, which means it's in standby status.
Press button "On" on the control panel or the remote controller to switch on the heater.
Then the blue indi
To switch off the heater, press the button "Off" on the control panel of the heater. When press the "Off" button on the contr
panel of the heater, the blue indicator light is off, and the remotrol is unfunctional. To press "Off" button
will only swift the appliance into standby status, and the blue indicator light is flashing.
The unit must be placed with the clearance of 100cm to the wall and 30cm to the ceiling .
The heater must be installed at least 1,8m above the floor.
The unit must be securely placed on a horizontal and flat surface.
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur whe
Don't place the unit close to curtain and/or other flammable objects.
Oth
erwise there will be a danger of catching fire.
Dont' cover the unit with anything during operation or a short time after it's shut down.
he power supply cord on the unit.
The unit must be handled with care, and avoid of vibration or hitting.
The unit must be securely grounded during operation.
When damaged, the unit must be repaired by professional reparing team.
ed, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
The heater must not be located immediately below a socket
-outlet.
When assembling, keep clear from any board or flammable material.
not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk
exists if the heater is covered or positioned incorrectly.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
nsure that they do not play with the appliance.
The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flamm
The head of the unit is at high temperature during operation. Unplug th
e unit and wait till it's cool before cleaning.
Don't use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
Don't use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
it as a cloth drier or towel drier.
Don't use this unit as a room heater of heat storing.
Don't use this unit in place of animal propagating and raising.
Don't use this unit in heating system of hot air centre.
Don't immerse this unit into water for cleaning.
The unit should be plugged in a socket, which is easily visible and reachable.
Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
e first few minutes after it's turned on. This is normal, and may not affect the performance of the unit
Unplug the unit before cleaning. It should be wiped with wet cloth. Don't use too much water.
supply is same as rated. When press the "On" button on the control panel,
Then the blue indi
cator light is on.
To switch off the heater, press the button "Off" on the control panel of the heater. When press the "Off" button on the contr
ol
panel of the heater, the blue indicator light is off, and the remotrol is unfunctional. To press "Off" button
on the remote control
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur whe
n
erwise there will be a danger of catching fire.
ed, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk
with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
The unit is for household use only. It's not allowed to use in building site, greenhouses, barn or stable where there's flamm
able
e unit and wait till it's cool before cleaning.
Two Dark points may exist on the surface of the heating elements, or the surface of the heating element may turn white during
e first few minutes after it's turned on. This is normal, and may not affect the performance of the unit
Downloaded from www.Manualslib.com manuals search engine
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SunRed WMC1800R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SunRed WMC1800R in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info