721408

SunRed SFT15 Manual

4
Zoom out
Zoom in
Previous page
1/61
Next page
www.sunred.nl
! CAUTION:
- Installation and repair should be done by a qualified service person.
- Improper installation, adjustment, alteration can cause personal injury or property
damage.
- Do not attempt to alter the unit in any manner.
- This appliance must be installed in accordance with the regulations in force.
- The gas cylinder must be stored in accordance with the regulations in force.
- Do not move the appliance when in operation.
- Shut off the valve at the gas cylinder or the regulator before moving the appliance.
- The tubing or the flexible hose must be changed within the prescribed intervals.
- In case of violent wind particular attention must be taken against tilting of the
appliance.
- Do not store or use gasoline or other flammable vapours or liquids into the heater
unit. The whole gas system, hose regulator, pilot or burner should be inspected for
leaks or damages before use.
- All leak tests should be done with a soap solution. Never use an open flame to check
for leaks.
- Do not use the heater until all connections have been leak tested.
- Turn off immediately the gas valve if smell of gas is detected.
- Do not transport heater while it’s operating.
- Do not move the heater after it has been turned off until the temperature has cooled
down.
- Keep the ventilation opening of the cylinder enclosure free and clear of debris.
- Do not paint radiant screen, control panel or top canopy reflector.
- Control compartment, burner and circulation air passageways of the heater must be
kept clean.
- Frequent cleaning may be required as necessary.
- The LP tank should be turned off when the heater is not in use.
- Check the heater immediately if any of the following exists:
o The heater does not reach temperature.
o The burner makes popping noise during use (a slight noise is normal when the
burner is extinguished).
o Smell of gas in conjunction with extreme yellow tipping of the burner flames.
- The gas regulator/hose assembly must be located out of pathways where people may
trip over it or in area where the hose will not subject to accidental damage.
- Any guard or other protective device removed for servicing the heater must be
replaced before operating the heater.
- Change the gas cylinder in a well-ventilated area, away from any inflammation
source.
- Check that the regulator seal is fitted and that it is in good condition.
- Do not obstruct the ventilation holes of cylinder housing.
- Adults and children should stay away from high temperature surface to avoid burns or
clothing ignition.
- Children should be carefully supervised when they are in the area of the heater.
- Clothing or other flammable materials should not be hung on the heater or placed on
or near the heater.
- Use may replace the rubber hose by himself and note the length of the hose is 60cm.
- The hose must be required by the national regulations and conditions.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SunRed SFT15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SunRed SFT15 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info