7
TO TURN ON THE HEATER
1. Depress and turn control knob clockwise to OFF posion.
2. Fully open gas valve.
3. Depress control knob and turn knob counter-clockwise to IGNITE posion, then to PILOT posion (you will hear 2 clicks).
4. With the pilot light lit, keep control knob depressed for 30 seconds.
5. Aer depressing the control knob for 30 seconds, turn control knob to LOW. To increase the temperature, turn towards HIGH.
TO TURN OFF THE HEATER
1. Fully close gas valve.
2. Turn control knob clockwise to OFF posion.
STORAGE
1. Always close the gas value of the gas cylinder aer use or in
case of a disturbance.
2. Remove the pressure regulator and the hose.
3. Check the ghtness of the gas valve and if you suspect a damage,
have it changed by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places
without adequate air venlaon.
CLEANING AND CARE
• Wipe o powder coated surfaces with so, moist rag. Do not clean heat-
er with cleaners that are combusble or corrosive.
• Remove debris from the burner to keep it clean and safe for use.
• Cover the burner unit with the oponal protecve cover when the heat-
er is not in use.
CAUTION
PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION
NOTE
If the pilot light has not ignited, turn heater control knob to OFF posion, fully close gas valve, wait 5 minutes, then repeat steps 2–4 of
the Lighng Instrucons.
NOTE
If the pilot light ignites but does not stay lit, turn heater control knob to OFF posion, fully close propane gas valve, wait 5 minutes, then
repeat steps 2–3. Now, using a lighter, ignite the pilot light through the ignion hole on the emier screen. Once the pilot light is lit, de-
press control knob for 30 seconds.
WARNING
Check that no broken on the glass is found before operaon.
O: The heater stop working
Hi: Maximum temperature posion
Lo: Minimum temperature posion
Vertaling variable control knob
Vertaling igniter
EN