OPERATION AND STORAGE
TO TURN ON THE HEATER
1. Turn on the valve on the gas supply cylinder completely.
2.
Push the control knob in it and turn it the “pilot ” position
3.
Press the "igniter " button several times to light the burner. Hold it for 30 seconds.
Release the Control Knob after the burner lights.
Note:
If a new tank has just been connected, please allows at least one minute for the air in the gas pipeline to purge out through the
pilot hole.
When lighting the pilot flame make sure that the variable control knob is continuously pressed down while pressing the igniter
button. Variable control knob can be released after the pilot flame lights.
Pilot flame can be watched and checked from the small round window with sliding lid located at the bottom of the flame screen
(to the left or right side of the controller).
If the pilot flame does not light or it goes out,REPEAT STEP 3.
A 5-minute complete shutoff period is necessary before relighting.
4. Turn the Control Knob to switch to desired temperature position.
TO TURN OFF THE HEATER
1.
Turn the knob to “LOW” position for small flame . See picture of “ ”.
2.
Turn the knob to “HI” position for big flame .See picture of “ ”.
3.
Press and turn the variable control knob to OFF position.
4.
Turn off the valve on the gas supply cylinder completely.
Variable control knob
lgniter
STORAGE
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Remove the pressure controller and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage, have it changed by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
CLEANING AND CARE
Wipe off powder coated surfaces with soft, moist rag. For lacquer surface, use suitable cleaners. Do not clean heater with
cleaners that are combustible or corrosive.
Remove debris from the burner to keep it clean and safe for use.
