www.sunred.nl
OPERATING INSTRUCTIONS
• Place the heater on a firm, level ceiling surface;
• The Ceiling hook must be suitably strong and be able to hold a minimum weight of 8 Kg.
• Place the Hook A around the Ceiling Hook and clip on any Ring of the Chain to adjust the height of the Patio Heater to the
Floor.
• The distance between the bottom of the Patio Heater to the Floor must be over 6.0 feet.
• Plug the Patio Heater into a grounded 220~240V 50Hz power outlet.
• Only operate the heater when it is in the upright position.
• Our Electric Patio Heater is equipped with three heat settings
• The switch on the heater head is used to control the three heat setting. (I) for 900w – (II) for 1200w – (I & II) for 2100W, The 0
position is off.
• To operate the heater on high, pull the Switch Cord again. This will cause both the bottom and top heating elements to glow
and radiate heat.
Touch switch
A. Press the touch switch one time to operate the heater on power (900W).
B. Press the touch switch twice to operate the heater on power (2100W).
C. Press the touch switch three times to operate the LED lights without heat.
D. Press the touch switch four times to operate the lights and to operate the heater on 2100 Power
E. Press the touch switch five times tot off the heat and lights
MAINTENANCE
• Unplug the unit and let it cool completely.
• To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary.
After cleaning, dry the unit with a soft cloth.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause
damage or deterioration to the surface of the heater.
• Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.
• Wait until the unit is completely dry before use.
STORAGE
• Ensure the unit is completely cold before storing in a cool, dry location.
