118724
83
Zoom out
Zoom in
Previous page
1/88
Next page
67
CHAPTER
11
System Shut-down
The shutdown or init command is executed by the super user to change the
operational state of the machine. By default, it brings the system to a state where
only the console has access to the operating system.
The shutdown command sends a warning message and a final message before it
begins shutdown activities. Refer to shutdown(1M) and init(1M) for further
information.
You can also use the following commands:
After shutting down the system, move the ON/STBY switch at the front of the
system cabinet to the STBY position and immediately release it.
To start the system again and begin the automatic booting sequence, you must set
the ON/STBY switch to the ON position and immediately release it.
TABLE 11-1 Commands for Shutting Down the System
Command Effect
shutdown -i0
or
init 0
Halt the operating system and enter the Open Boot PROM (OBP).
shutdown -i5
or
init 5
Halt the operating system and power the system down.
shutdown -i6 Return to interactive mode and immediately reboot from the default
kernel/unix (the reboot command has the same effect).
init s
or
init S
Halt the operating system and enter maintenance mode.
LW3User.book Page 67 Wednesday, November 10, 1999 9:00 AM
83


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sun Netra 1400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sun Netra 1400 in the language / languages: English as an attachment in your email.

The manual is 2,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info