PART 1
•
English
29
5.1.4.2 LNB Set-up
It is recommended that you read the manual and installation instructions of your LNB,
your DiSEqC switch, your 0/12V switch and your Positioner before you start setting up
your LNB. To set up your LNB, please apply the following steps:
1. Press the Menu button.
2. Using UP/DOWN keys, select "Installation" and press OK.
3. Using UP/DOWN keys, select "LNB Set-up" and press OK.
4. Check the exact specifications of your LNB through the manufacturers information
or your dealer. There are up to 16 types of LNB's available. The Default is set to
Universal mode (9750/10600MHz), DiSEqC is not used and the LNB is mounted
on a fixed dish.
5. Use the UP/DOWN keys on your remote to select an item and use the
LEFT/RIGHT buttons to set up any values.
LNB: Up to 16 LNBs are available, select and set-up the correct one
according to your LNB specifications. Press OK on the LNB number that
you want to set-up.
LNB Type: Select the LNB type from Universal 1 ~ 3, and Single. You
should type the LNB value in Single. In Single, the item parameter is 0 or
another number. In UNI1=9750/10600 MHz, UNI2=9750/10700 MHz,
UNI3=9750/10750 MHz.
LNB Power: Select 13/18V, 13V or 18V for LNB. Select “Off” if you want
to switch the power of the LNB off.
LNB Dish: Using the Left/Right buttons, select “Fixed” or “Motorised”
(Move) Dish. If you use a motorised dish, read the “Positioner Set-up”
DiSEqC switch: The default is Off. To use the DiSEqC switch, set up the
DiSEqC version you have (V1.0 or V1.1).
DiSEqC Input: Select position 1~4 if DiSEqC switch is DiSEqC V1.0.
Select position 1~16 if DiSEqC switch is DiSEqC V1.1.
DiSEqC Repeat: Designate the repeat of switching (0 ~ 3).
Switch 22 kHz: You can set the 0/22 kHz switch to ON or OFF.
