480578
17
Zoom out
Zoom in
Previous page
1/46
Next page
17
Installation
ENGLISH
www.strongsat.com
RF Tuning
If you have connected up your equipment via RF leads, you may need
to perform RF tuning before you can watch digital satellite TV.
RF tuning your TV (and VCR) to your set-top box
1. Make sure your set-top box is out of standby (the standby light
on the front panel should be green).
2. Consulting your TV’s user guide if necessary, tune the TV until
you can see the Countries screen (see page 16) on your TV
screen.
3. Store your new ‘channel for digital satellite TV’ on a TV channel
number of your choice. For example, if your terrestrial channels
are channels 1 to 5, and your ‘VCR channel’ is channel 8, you
may wish to use TV channel 9 as your ‘channel for digital satellite
TV’.
4. If you have a VCR, set your TV to its ‘VCR channel’, then tune
your VCR until you can again see the Countries screen.
If you cannot RF tune your TV (or VCR) to your set-top
box...
Your set-top box’s factory preset RF output channel is channel 38. (This
is not the same as a TV channel).
If channel 38 is not compatible with your TV, for example if it is already
being used as your VCR’s output channel, or for a terrestrial channel,
you may find you cannot tune your TV to your set-top box because of
interference.
Changing the RF output channel is covered in the setup section (see
page 35).
RF channels may also be known as UHF channels.
Note
If you have previously had an analogue satellite receiver connected to
your TV (and/or VCR), you may find that your ‘channel for satellite TV’
still works for your new digital channels. Try it to see - if it works you
do not need to perform RF tuning.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT6750 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT6750 in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info