480561
19
Zoom out
Zoom in
Previous page
1/21
Next page
16
Українська
No video or audio On TV set selected not
correct input.
Select correct input source on
your TV.
Check correct connection.
Connection done not properly. Make sure connectors are
of good quality. Disconnect
receiver and TV set from the
main power. Disconnect cable,
connecting receiver and TV set
from the both devices. Connect
the cable to both devices,
making sure proper connection.
Video is “mosaic”, sound is noisy
or disappear time to time
Low signal level due to bad
weather conditions.
For stable reception of the
signal you may need to replace
antenna to the better one.
Antenna damaged or covered by
ice (winter time). Damaged cable
from antenna to receiver.
Check antenna and cable.
Indoor antenna has been moved
from good position and not
provide necessary level of signal.
Setup antenna to good point.
Check signal level and quality
(see § 5.5)
Power of indoor active antenna
is disabled.
Enable antenna power as
described in § 6.2.1
Message “No rights” or “Pay
TV channel”
Channel is encrypted. Possible this channel belongs
to the package you are not
subscribed to. Consult to
Customer support of operator.
Not possible to control receiver
by remote control
Batteries life time is ended. Replace the battaries.
IR sensor is closed by some
object (obstacle between RCU
and receiver).
Remove obstacles.
Point your RCU to the receiver.
The receiver is switched off. Turn receiver ON.
Forget your PIN code Consult to service in your region
or send e-mail to support
through www.strong.tv
8.0 TECHNICAL SPECIFICATION
Tuner
Input connector: IEC60169-2, female, 75 Ohm nominal
Input frequency range: VHF: 177.5 ~ 226.5 MHz
UHF: 474 ~ 858 MHz
Input signal level: -82 ~ -25 dBm
Antenna power: 5 V DC, max. 50 mA, short cut protected
Demodulation DVB-T/T2
Demodulation: Compliant to DVB-T (EN 300 744), DVB-T2 (EN 302 755)
Demodulation modes: QSPK, 16/64/256 QAM
Bandwidth: 7 or 8 MHz
FFT mode: 1K, 2K, 4K; 8K, 16K, 32K and extended normal
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT 8502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT 8502 in the language / languages: English as an attachment in your email.

The manual is 1,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info