nIt is advised not to store important information on USB storage devices used with
the receiver. Always make backups of data on your USB storage device before using
it with this receiver. STRONG will not take responsibility for any loss of information or
circumstances caused by loss of information.
nSTRONG cannot guarantee the playback of all les although extensions are listed, as it
depends on le size, codec, bit rate and resolution.
nPlease ensure that either the USB device is already formatted to FAT/FAT32, or format
the USB device via your receiver, refer to chapter 7.7 USB for details.
*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via USB has
not yet been installed.
2.0 YOUR RECEIVER
2.1 PIN code default: 0000
2.2 Front and side panel
Fig. 1
1. Standby indicator:Shows power state of the receiver
Green LED - receiver is turned on
Red LED - receiver is in standby mode
2. Remote control sensor:
Receives the signal from the remote control
3. USB For connection of USB device for Multimedia use
2.3 Rear panel
Fig. 2
1. SAT IN To connect to the LNB of your satellite dish for reception of
satellite broadcast signal
2. EthernetTo connect to a network switch, router or modem
3. HDMI To connect to the HDMI input of your TV using a good quality
HDMI cable
4. S/PDIF coaxial To connect to a digital or home cinema audio amplier
5. Audio L/RTo connect to an analogue amplier for stereo audio
6. Power connector The receiver requires a wall adapter, mains voltage input
100~240V AC 50~60Hz 12V, 1.5A DC output. Please check the
local power conditions before connecting the receiver to the
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Strong SRT 7008 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Strong SRT 7008 in the language / languages: English as an attachment in your email.
The manual is 0,88 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.