751646
13
Zoom out
Zoom in
Previous page
1/32
Next page
9
NOTE If Germany or Italy is selected as country, a pre-installed channel list is
available. German channels from ASTRA 19.2E will be installed. Italian
channels from Hotbird 13E will be installed.
You can continue to Channel search and install further channels as described below or directly go to
viewing mode by pressing OK to start enjoying the pre-installed channels immediately.
4.1 Dish setup
4.1.1 Satellite Selection
Use p/q to highlight the satellite your dish is aimed at. When using a multi feed antenna with more
than 1 LNB, select the satellites your antenna is adjusted for by pressing OK and set the appropriate
LNBs in the right-hand screen by pressing u at the DiSEqC 1.0 or, if applicable, DiSEqC 1.1 option. The
scan process will then search on all selected satellites. If using motorized antennas or SatCR, please
refer to chapter 7.
4.1.2 Signal Adjust
The signal Strength and Quality bar on the bottom of the screen allows you to ne tune the
alignment of your antenna for optimum reception. Adjust your antenna for maximum possible signal
strength and quality. When the signal cannot be improved anymore, x the dish on this position and
press the BLUE button for Scan options and scan.
4.1.3 Scan Mode
Use p/q to highlight the options of choice and press BLUE to start the scan. It is recommended to
use the default settings.
4.1.4 Scan
Your receiver will now perform an automatic channel search. When the process has been completed,
all found channels will be stored and the receiver will switch to the rst found channel. You are now
ready to enjoy your new receiver.
NOTE If no channels were found during the automatic channel scan, the receiver
will return to Installation guide menu. Please select your language again
and refer to chapter 7.3 for further instructions.
5.0 QUICK GUIDE FOR USING YOUR RECEIVER
We at STRONG understand that you can’t wait to enjoy your new HD receiver. The following quick
guide will make you familiar with the basic operation of this device. We do, however, advice you to
read the full manual to get the best performance from your STRONG HD receiver.
To turn your receiver ON or to Standby, press q on the remote control.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Strong SRT 7007 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Strong SRT 7007 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Strong SRT 7007

Strong SRT 7007 User Manual - German - 40 pages

Strong SRT 7007 User Manual - French - 32 pages

Strong SRT 7007 User Manual - Spanish - 35 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info