518675
15
Zoom out
Zoom in
Previous page
1/15
Next page
Horizontal Adjustment
14
MX800
MX850
MX800
MX800
MX850
1. Please check all cable connection is well connected.
2. The treadmill did not move after pressing "Start" and show E1 , please check if there is any part stuck.
3. The treadmill run for few seconds after pressing "Start" but stops, please check if the sensor
(near flywheel of front roller) is loose or defective.
4. Please check wires connected to motor are loose or not.
5. Please contact stores for service if E1 can not be solved.
When E6/E7 is displayed , remove safety key and insert it again to restart treadmill . If E6/E7 is still shown on
display, please check the following or call for service.
1. Reset incline value
(1) When the position of incline is lower than middle level, press " Mode" and incline "up" buttons. Hold both
buttons and the incline will be raised. Release the two buttons till the incline position is up to middle level.
(2) When the position of incline is higher than middle level, press " Mode" and incline "down" buttons. Hold both
buttons and the incline will be reduced. Release the two buttons till the incline position is down to middle level.
Please try it for few times. If you can not get the incline move, please contact stores for service.
Once the incline position is at middle level, please turn off power and re-start. Please see if E6 / E7 goes away.
If not, please contact stores for service.
2. Please check if red / white incline cables are well connected to MCB.
3. If the above steps can not reset incline , please contact stores for service.
Step1
Step3
Step2
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StrengthMaster MX-850 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StrengthMaster MX-850 in the language / languages: English as an attachment in your email.

The manual is 10,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info