659716
38
Zoom out
Zoom in
Previous page
1/52
Next page
INSTALLATION - 70CM
Before you start
Please read the instructions carefully -
planning your installation will save you
time and effort.
Look at the different ways the appliance
can be installed - as shown on the
following pages - and plan the installation
to suit your situation.
Leave the appliance in the base tray
packaging until you are ready to install
it. When you remove the appliance from
the base tray packaging, take care not to
damage it.
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective gloves
during installation.
Please note that the weight of this
appliance is approximately 47kg
(unpacked).Takecarewhenliftingitinto
the housing unit - always use an appropri-
ate method of lifting.
This appliance must be installed only at
low level - ie; under a worktop. The
controls have been designed for viewing
at a low level, and it should therefore not
be installed at high level.
Please note that all dimensions and sizes
given are nominal, some variation is to be
expected.
If this appliance is to be installed near to
a corner where the adjacent cabinets run
at right angles forward of the appliance,
there must be a gap of at least 90mm
between the appliance and the cabinets,
to prevent overheating of the cabinets.
Important: Do not modify the outer
panels of this appliance in any way.
Fixingscrews-Thexingscrewsareina
polythene bag in the oven pack. Depend-
ing on the method of installation, some of
the screws may not be needed.
Step1:Prepareforinstallation
There are 3 methods of installing the ap-
pliance:
• Method1:Intoaspacebetweentwo
base units, ie; without a housing unit.
• Method2:Intoahousingunit,
with an internal height of less than
710mm,whichcanbemodiedtoob-
tain the required dimensions.
• Method3:Intoahousingunit,with
an internal height of 710mm or more.
If you have a non standard size of
cabinet which leaves a gap above or
below the appliance, you may be able
tobuyatrimkit(tollinthegap)
from the supplier of your cabinets.
Quantity Colour Description For Fixing
6 Silver No 8 x 12mm long
Self tapping screw
Runners to appliance
12 Black No 8 x 12mm long
Chipboard screw
Runners and sidetrims to
cabinet or housing
6 Black No 8 x 25mm long
Chipboard screw
Appliance to cabinet
2 Silver No 8 x 12mm long
Self tapping screw
Appliance to sidetrims
38


Need help? Post your question in this forum.

Forumrules
1

Forum

stoves-seb600mfs

Reset search

  • How do I replace the seal to the oven door oven type ST SEB600MFS. Submitted on 25-9-2023 at 17:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stoves SEB600MFS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stoves SEB600MFS in the language / languages: English as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info