Manual Stoves Richmond 900DFT (page 42 of 52) (English)

659706

Zoom out

Zoom in

1/52

Fitting the plinth (if applicable)

 Make sure the appliance is raised to a height of 915mm

or above before beginning. If the appliance is below

915mm - you can only fit the plinth cover labelled Y.

You can adjust the height using the feet (1) of the

appliance.

If your appliance has a storage drawer at the bottom,

you access the required holes through the base of the

drawer after lifting the mat.

 Open the appliance doors, and loosen screw A located

on bracket (2). Do not remove this screw entirely.

 Insert screw B, through slot (3) and screw into the small

hole at the bottom of bracket (2).

Make sure that the plinth cover is flush to the appliance,

but not over tightened.

Fitting the splashback (if applicable)

 Loosley fit screw A and nut B into hole 1 at both ends of

the rear surface of the appliance.

 Locate fitted screw A through the slots in both of the

metal splashback plates.

 Tighten screw A and nut B.

 Now locate and tighten screw C and nut D through hole

(2) at both ends of the rear surface of the appliance.

Make sure that the splashback is securely attached, but

avoid over tightening.

Fitting the towel rail (if applicable)

 On the towel rail there are two hole, top (A) and bottom

(B), these holes have corresponding holes on the fascia

at each end.

 The screw for the top hole (A), must be screwed into

the supplied adaptor, whereas the remaining screw just

goes through the bottom hole (B). Both screws are M6

screws. Using the allen key provided, tighten the screws

making sure that the towel rail is flush to the fascia,

but not over tightened.

Installing Your Cooker

(1)

(2)

(3)

Door

Plinth cover

Oven cavity

(1)

(2)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stoves Richmond 900DFT in the language / languages: English as an attachment in your email.

The manual is 0,92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stoves Richmond 900DFT Manual

Product: