813429
10
Zoom out
Zoom in
Previous page
1/44
Next page
10
12
-
+
Control Knob
Setting
Indicator
5.24 The exact setting of the thermostat and the Manual Air
Controls may need slight adjustment by trial and error to suit
requirements.
Operate the follow controls manually:
Secondary Air Control
Depending on the strength of the flue pull the Secondary
Air Control should be adjusted so that air from the air inlets
ignite unburnt smoke and flames are visible, but not so
strong that flames reach the glass.
Primary Air Control
Small amounts of Primary Air can sometimes help to
maintain a hot fuel bed and boost hot water output.
Airwash Control
Opening the Airwash Control will increase the visual flame.
Do not burn large amounts of fuel with the Airwash
Control closed for long periods of time. This reduces the
glass cleaning effect of the Airwash and causes tars and
creosotes to build-up in the appliance and flue system.
5.25 Experience establishes settings to suit personal preference.
Over-firing
5.26 When in use, burning the appliance at a high temperature
for a short period reduces tars and creosotes.
DO NOT OPERATE THE APPLIANCE WITH THE PRIMARY
AIR CONTROL OPEN FOR LONG PERIODS OF TIME AS
THIS COULD CAUSE OVER-FIRING AND MAY CAUSE
PERMANENT DAMAGE.
Shut Down
5.27 If there is still burning fuel in the firebox, Stovax do not
recommend shutting down the air controls completely
unless there is a chimney fire in progress (see section 10
for advice). Closing the controls during the burning process
will cause poor combustion and could lead to a build up of
gasses that could ignite dangerously.
5.28 Always have enough air entering the appliance to maintain
some flame within the firebox.
5.29 If it is necessary to shut down the appliance then run on a
high setting until all of the fuel has been burnt before closing
the air controls.
6. Woodburning Tray
In order to burn wood continuously in a Multi-fuel appliance
a Woodburning Tray must be fitted.
For details on purchasing a Woodburning Kit for this
appliance contact your retailer.
Front edge
13
6.1 Remove the riddling mechanism from the appliance
(see Pre-Installation, Section 5).
To fit the Wood Burning Tray:
6.2 Remove the log guard and ashpan.
6.3 Hold the tray flat with the front edge pointing forwards, tilt
diagonally and insert through the front of the appliance,
see Diagram 14.
Ensure that the lower log guard support is inserted first to
achieve the correct angle.
14
Log guard
support
6.4 Place tray flat on the fixings on the firebed,
see Diagram 15.
15
Care & Maintenance
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stovax View High Output Boiler Stoves at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stovax View High Output Boiler Stoves in the language / languages: English as an attachment in your email.

The manual is 4.95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info