813435

Stovax Studio Air Manual

5
Zoom out
Zoom in
Previous page
1/32
Next page
5
RUNNING THE APPLIANCE
Wood burns best on a bed of ash. The raised ribs on the grate are
a good indication of the ideal depth.
Rake the embers evenly over the firebed and open the Airwash
Control fully for a few minutes before re-fuelling.
Add new logs and stack in an open arrangement to enable the
wood to burn effectively.
Compact Stacking
Open Stacking
Close the door immediately after refuelling.
REFUELLING
FEEDING FUEL
APPLIANCE WOOD LENGTH DIAMETER
FUEL CONSUMPTION
KG/HOUR
WOOD
Studio Air 1 375mm 126mm 1.6
Studio Air 2 450mm 126mm 2.51
Do not burn large amounts of fuel with the Air Controls closed
(Shutdown position) for long periods of time. This reduces the
glass cleaning effect, causes tars and creosotes to build-up in the
appliance and ue system and will produce excessive amounts of
smoke.
When in use, running the appliance at a high temperature for a
short period also reduces tars and creosote.
When running the appliancerefuellittleandoftenforefcient
burning.
Do not refuel when a large amount of flames are in the
firebox as this could cause smoke or flames to spill into the
room.
Abrightandcleanreboxindicatestheapplianceisburning
well.
Do not load fuel above the log guard and the Secondary
CombustionInletsatthebackoftherebox.
The maximum amount of fuel specied in this manual should not
be exceeded, overloading can cause excess smoke.
Refuel a little and often to ensure a bright and clean burning stove.
Do not overload the firebox as this will cause poor
performance and excessive smoke.
After refuelling:
Burn at a high temperature for a few minutes before adjusting
the Air Controls.
WARNING: DO NOT OPERATE THE APPLIANCE WITH THE
AIR CONTROL ON START UP FOR LONG PERIODS OF TIME
AS THIS COULD CAUSE OVER-FIRING AND MAY CAUSE
PERMANENT DAMAGE.
RECOMMENDED FUELS
WOOD LOGS:
Burn only seasoned timber with a moisture content of less than
20%. To ensure this allow cut wood to dry for 12 to 18 months.
DO NOT BURN construction timber, painted, impregnated /
treated wood, manufactured board products or pallet wood.
DO NOT USE any form of candle as fuel. Melted wax will
damage the appliances moving parts.
Choosing fuel:
All types of wood can be used as fuel in the appliance. Different
types of wood have different densities: the greater the density of
the wood the greater the energy value.
Oak, beech and birch have the highest value.
The correct moisture content for firewood that is ready to burn is
below 20% moisture content.
If wood is too wet, it will be difficult to light, struggle to burn, give
very little heat output and tar up the flue.
This could lead to a chimney fire, so it is important to burn
sufficiently dried firewood.
Dry wood gives more heat output, avoids blackening the appliance
glass and there is minimal soot build up in the chimney or flue.
More heat output equals less fuel.
Do not burn construction timber, painted,
impregnated / treated wood, manufactured board
products or pallet wood.
Wood Storage:
To ensure thoroughly dry wood, cut in winter and store under a roof
with plenty off room for air circulation.
Do not cover completely, leave a gap for air to pass over the wood
and do not seal.
Bring wood intended for use inside and store for a few days
prior to burning to ensure that the moisture has been sufficiently
decreased.
GB
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stovax Studio Air at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stovax Studio Air in the language / languages: English, French, Italian as an attachment in your email.

The manual is 2.34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info