597138
43
Zoom out
Zoom in
Previous page
1/48
Next page
43
HARD DISK DRIVE INSTALLATION
If you wish to replace the pre-installed HDD with a higher capacity drive, follow these instructions. If you are at all
hesitant to perform the following procedure, please refer to qualified service personnel.
Follow these steps to install a HDD:
CAUTION
When working with electrostatic sensitive devices such as a Hard Disk Drive (HDD) or DVR unit, make
sure you use a static-free workstation. Any electrostatic energy coming in contact with the hard disk
or DVR can damage it permanently.
1. Remove the 4 screws (2 each side) which hold the cover in place, then slide it off. With the front panel
facing you, the HDD mounts to the left of the chassis. There are 4 screw holes to mount the HDD.
2. Align the HDD with the mount points (circled in red above) and secure in place using 4 screws (provided)
through the underside of the chassis.
3. Connect the SATA and POWER cables to the HDD.
CAUTION
SATA and POWER cables are designed to fit only one way. Do not force them into place or you may
damage the HDD.
4. Replace the cover and secure it in place using the 4 screws removed in step 1.
5. You must format (prepare) the HDD before it can be used for recording.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Storage Options 53882 - DIY Home CCTV Kit Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Storage Options 53882 - DIY Home CCTV Kit Plus in the language / languages: English as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info