52219
33
Zoom out
Zoom in
Previous page
1/124
Next page
MS 650, MS 660
English
31
Positions of the Master Control lever
Stop 0 – engine off – ignition is switched
off
Operating position F – engine is
running or can start
Warm start
n – this position is for
starting the warm engine – the Master
Control lever returns to the operating
position when the throttle trigger is
squeezed
Cold start l – this position is for
starting the cold engine
Adjust Master Control lever
To adjust the Master Control lever from
the operating position F to cold start l,
press and hold down the throttle trigger
lockout and throttle trigger
simultaneously – set Master Control
lever.
To set the Master Control lever to warm
start n, first set it to cold start l, then
push the Master Control lever into the
warm start n position.
Switching to the warm start n position
is only possible from the cold start l
position.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the warm start n position
to the operating position F.
To switch off the engine, set the Master
Control lever to Stop 0.
Position cold start l
if engine is cold
if the engine stalls during opening of
throttle after starting
the fuel tank has run empty (engine
stalled out)
Position warm start n
if engine is warm (once the engine
has been running for approx. one
minute)
when the engine has turned over for
the first time
after ventilation of the combustion
chamber, if the engine was flooded
Holding the chain saw
There are two ways to hold the chain
saw during starting.
On the ground
N Place the chain saw securely on the
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
N With the left hand on handlebar,
press the chain saw firmly against
the ground – thumb wrapped
around the handlebar
N Place your right foot through the
rear handle
Starting / Stopping the
Engine
STOP
0
001BA140 KN
143BA018 KN
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS660 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS660 in the language / languages: Spanish as an attachment in your email.

The manual is 4,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stihl MS660

Stihl MS660 User Manual - English - 134 pages

Stihl MS660 User Manual - German, Dutch, French, Italian - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info