537132
92
Zoom out
Zoom in
Previous page
1/122
Next page
91MS 240, MS 260, MS 260 C
Position the end cover (1) so that
the idle speed screw (arrow) is at
the same side as the adjusting
screws.
: Place the end cover (1) against
the carburetor body from below
so that the gasket and pump
diaphragm are still held in
position.
Align the end cover (1) so that its
pegs engage the holes in the
carburetor body.
Check that diaphragm and
gasket are properly seated.
: Insert screw and tighten it down
firmly.
Reassemble all other parts in the
reverse sequence.
165RA362 TG
1
165RA363 TG
14.4.4 Choke Shaft / Choke
Shutter
The choke shutter is in the air filter –
see chapter on 'Air Filter' and
instruction manual.
14.4.5 Adjusting Screws
Grommets have been removed for
the sake of clarity.
There are three adjusting screws on
the carburetor:
H = high speed screw (1)
L = low speed screw (2)
LA = idle speed screw (3)
If the carburetor cannot be adjusted
properly, the problem may be the
adjusting screws.
The high speed screw H has a
limiter cap, which has to be
removed before the screw is
removed.
Always install a new limiter cap.
Remove the carburetor, b 14.2
See also carburetor
troubleshooting, b 4.6
165RA364 TG
1
2
3
: Pull off the grommets (1 and 2).
Low speed screw
: Take out the low speed screw (1).
Inspect the sealing ring (1),
washer (2) and spring and
replace if necessary.
: Inspect the tip (arrow) for
damage or wear and replace the
screw (L) if necessary.
Screw down the low speed screw
(L) as far as stop.
Continue with high speed screw.
165RA365 TG
1
2
165RA366 TG
1
165RA367 TG
1 2
3
92


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS 240 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stihl MS 240

Stihl MS 240 User Manual - German, Dutch, French, Italian - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info