537132
77
Zoom out
Zoom in
Previous page
1/122
Next page
76 MS 240, MS 260, MS 260 C
12. Control Levers
12.1 Switch Shaft
The following positions can be
selected with the switch shaft:
–Position
0 = engine off
– ignition is switched off
–PositionF = normal run position
– engine runs or may start in this
position
To move the switch shaft from F to
k or l depress the interlock lever
and throttle trigger at the same time.
–Positionk = warm start
– warm engine is started in this
position
The switch shaft returns to the run
position when the throttle trigger is
operated.
–Positionk = cold start
– cold engine is started in this
position
165RA281 TG
12.1.1 Removing and Installing
Remove the air filter, b 14.1
Remove the handle molding,
b 12.2
: Disconnect the throttle rod (1)
from the trigger (2).
: Pull terminal sleeve (arrow) of
short circuit wire (1) out of the
switch shaft.
165RA282 TG
1
2
165RA283 TG
1
: Pry the switch shaft (1) out of its
mount (arrow).
Lift the switch shaft (1) a little and
pull it out of the mount (2).
Check the switch shaft (1) and
replace if necessary
Line up the switch shaft
– the arm (arrow) must point in
the direction of the throttle trigger.
: Push the switch shaft into the
mount (1).
165RA284 TG
1
2
165RA285 TG
1
77


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS 240 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stihl MS 240

Stihl MS 240 User Manual - German, Dutch, French, Italian - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info