537241
9
Zoom out
Zoom in
Previous page
1/76
Next page
FH
deutsch
7
Anbau vorbereiten
WARNUNG
Für den Umbau des Basis-Motorgerätes
immer den Motor abstellen –
Verletzungsgefahr!
HINWEIS
Anbau und Abbau des
Anbauwerkzeuges müssen immer an
einem sauberen Platz durchgeführt
werden.
Sollte sich am Basis-Motorgerät bereits
ein Getriebe bzw. ein Anbauwerkzeug
befinden, dann muss dieses zuerst
abgebaut werden.
N am Basis-Motorgerät die
Klemmschrauben am
Getriebegehäuse (Pfeile) lösen und
das Getriebe vom Schaft abziehen
Beim Abziehen des Getriebes kann die
Antriebswelle aus dem Schaft gleiten,
diese muss dann wieder in den Schaft
zurückgeschoben werden.
Die Antriebswelle darf nur L = 22 mm
(7/8 in.) aus dem Schaft ragen. Wird
dieses Maß nicht erreicht, Welle unter
leichtem Druck langsam drehen bis sie
sich auf das angegebene Maß
einschieben lässt.
Anbauwerkzeug anbauen
228BA055 KN
FCS
BF
HL
HT
FS
SP 10
SP
381BA015 KN
L
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl FH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl FH in the language / languages: German, Dutch, French, Italian as an attachment in your email.

The manual is 2,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info