52126
22
Zoom out
Zoom in
Previous page
1/27
Next page
When starter rope is fully extended,
it must be possible to rotate the rotor
another one half turn.
If this is not the case,
the spring is overtensioned and
could break.
Take one turn of rope off the
rotor.
Secure the starter cover.
Tighten down the housing screws
firmly.
5HSODFLQJDEURNHQUHZLQGVSULQJ
Lubricate the new spring with a
few drops of non-resinous oil -
do not open the wire retainer.
Remove the rope rotor.
Remove parts of old spring.
Fit the new spring -
position outer spring loop in the
recess - the wire retainer
slips off in this process.
If the spring pops out and uncoils:
Refit it in the counterclockwise
direction -
start outside and work
inward.
Install the rope rotor.
Tension the rewind spring.
Fit the starter cover.
Tighten down the housing screws
firmly.
355BA022 KN
a = 2mm
(0.08in)
'XULQJEUHDNLQSHULRG
A factory new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period.
As all moving parts have to bed in
during the break-in period, the
frictional resistances in the engine
are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
'XULQJRSHUDWLRQ
After a long period of full-throttle
operation, allow engine to run for a while
at idle speed so that the heat in the
engine can be dissipated by flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
$IWHUILQLVKLQJZRUN
Storing for a short period:
Wait for engine to cool down. To avoid
condensation, fill the fuell tank and
keep the unit in a dry place until you
need it again.
Storing for an long period:
see chapter "Storing the Machine".
2SHUDWLQJ,QVWUXFWLRQV
%* 
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl BG75 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl BG75 in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info