52149
9
Zoom out
Zoom in
Previous page
1/54
Next page
Preparation for the use of the saw
Take off the chain guard and inspect for
safety in operation. For assembly, follow
the procedure described in the chapter
“Mounting the Bar and Chain” of your
Owner’s Manual.
STIHL Oilomatic chain, guide bar and
sprocket must match each other in
gauge and pitch.
Before replacing any bar and chain,
see the sections on “Specifications”,
"Kickback" and the "ANSI B 175.1-1991
chainsaw kickback standard" in this
manual.
!
Warning!
Proper tension of the chain is extremely
important. In order to avoid improper
setting, the tensioning procedure must
be followed as described in your manual.
Always make sure the hexagonal nut(s)
for the sprocket cover is (are) tightened
securely after tensioning the chain.
Never start the saw with the sprocket
cover loose. Check chain tension once
more after having tightened the nut(s)
and thereafter at regular intervals (when-
ever the saw is shut off). If the chain
becomes loose while cutting, shut off the
engine and then tighten. Never try to
tighten the chain while the engine is
running!
Fueling
Your STIHL chainsaw uses an oil-gaso-
line mixture for fuel (see chapter “Fuel”
of your Owner’s Manual).
!
Warning!
Gasoline is an extremely flammable fuel.
If spilled or ignited by a spark or other
ignition source, it can cause fire and
serious burn injury or property damage.
Use extreme caution when handling
gasoline or fuel mix.
Do not smoke or bring
any fire or flame near the
fuel or the chainsaw.
Note that combustible
fuel vapors may be vented
from the fuel system.
Fueling Instructions
!Warning!
Fuel your chainsaw in well-ventilated
areas, outdoors only. Always shut off the
engine and allow it to cool before refue-
ling. Gasoline vapor pressure may build
up inside the gas tank of a two cycle
engine depending on the fuel used, the
weather conditions, and the venting
system of the tank. In order to reduce
the risk of burns or other personal injury
from escaping gas vapor and fumes,
remove the fuel filler cap on the STIHL
product carefully so as to allow any
pressure build-up in the tank to release
slowly. Never remove fuel filler cap while
engine is running.
Select bare ground for fueling and move
at least 10 feet (3 m) from fueling spot
before starting the engine. Wipe off any
spilled fuel before starting your saw, and
check for leakage.
!Warning!
Check for fuel leakage while refueling
and during operation. If fuel or oil leakage
is found, do not start or run the engine
until leak is fixed and spilled fuel has
been wiped away. Take care not to get
fuel on your clothing. If this happens,
change your clothing immediately.
7
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl 044 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl 044 in the language / languages: English as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info