52138
27
Zoom out
Zoom in
Previous page
1/54
Next page
You can run chains of different pitches
on this chainsaw - depending on the
chain sprocket (see “Specifications”)
The chain pitch must match the guide
bar. In addition, the drive link gauge
must match the guide bar groove width.
Unscrew nuts and take off cover.
Turn tensioning screw (1) counter-
clockwise until the tensioning nut (2)
butts against left end of housing slot.
Wear work gloves to protect hands
Fit the chain - start at the bar nose -
disengage the chain brake:
Pull hand guard (3) toward
the front handle.
Fit the guide bar over the studs (4)
so that the chain cutting edges on
the top of the bar point toward the
bar nose.
Engage the peg of the tensioner
slide in locating hole (5) - place the
chain over sprocket (6) at the
same time.
Now turn tensioning screw (7)
clockwise until there is very little
chain sag on the underside of the
bar - and the drive link tangs are
located in the bar groove.
Refit the sprocket cover - and
screw on the nuts only fingertight.
Now refer to chapter “Tensioning
the Saw Chain”.
Mounting the Bar and Chain
Models with Front Chain Tensioner
143BA005 KN
4
5
6
7
4
143BA003 KN
143BA034 KN
143BA004
3
1
2
143BA035 KN
017, 018 25
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl 017 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl 017 in the language / languages: English as an attachment in your email.

The manual is 2,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info