608747

Stiga SPR 255 Manual

38
Zoom out
Zoom in
Previous page
1/508
Next page
IMPORTANT
To avoid breaking the starter
rope, do not pull the whole length of it or let it slide
along the edge of the cable guide hole. Release
the starter gradually, to avoid letting it y back un-
controllably.
7.  Push the choke knob inward halfway. 
8. Pull the starter rope again until the engine starts
as normal
NOTE
If the starter rope is pulled
repeatedly with the choke on, it may ood the en-
gine and make starting dicult. If you have ooded
the engine, remove the spark plug and gently pull
the handle on the starter rope to eliminate any
excess fuel; then dry the spark plug electrodes and
replace it on the engine.
9. When the engine has started, press the throttle
trigger to disconnect the starter and allow the
engine to idle.
IMPORTANT
Do not let the engine run at
high power with the chain brake engaged, as this
could cause overheating and damage to the
clutch.
10. Let the engine run idle for at least 1 minute
before using the machine.
• Hot starting
When hot starting (immediately after stopping the 
engine), follow the procedure indicated above in 
points 1 - 2 - 5 - 6 - 9.
WARNING!
Carefully follow the in-
struc tions under “For your safety” (
3.1).
USE OF THE ENGINE (Fig. 10)
IMPORTANT
Always disengage the chain
brake, pulling the lever towards you before using
the accelerator.
The chain speed is regulated by the throttle trigger 
(1) on the rear handgrip (2).
The throttle trigger only works if the lockout (3) is 
pressed at the same time.
The movement is transmitted from the engine to
the chain  by a  centrifugal mass  clutch  that pre-
vents the chain from moving when the engine is
running at minimum speed.
STARTING THE ENGINE
WARNING!
The engine must be
start ed in an area at least 3 metres from where
you relled the fuel tank.
Before starting the engine:
–   Place the machine rmly on the ground.
–   Take o the bar cover.
–   Make sure the bar is not touching the ground or 
any other object.
• Cold starting
NOTE
A “cold” start of the engine
means starting it after at least 5 minutes from when
it was switched o or after refuelling.
To start the engine (Fig. 8):
1.   Check that the chain brake is engaged (with the 
front hand guard pushed forward).
2.   Set the switch (1) to «START».
3.   Pull the knob (2) as far as possible to engage 
the starter.
4.   Press the primer device button (3) 3 or 4 times 
to prime the carburettor.
5. Hold the machine rmly on the ground with one 
hand on the grip, in order not to lose control of
the machine during start-up (Ill. 9).
WARNING!
If the machine is not held
rmly, the force of the engine could cause the
user to lose his balance or direct the bar to-
wards him or an obstacle.
6.   Pull the starter rope slowly for 10 - 15 cm until 
you feel some resistance, then tug it hard a few 
times until you hear the engine turn over.
WARNING!
Never wind the starter ca-
ble around your hand.
DANGER!
Never start the chain saw
by holding on to the starter cable and allowing
it to fall. This is an extremely dangerous
method as you lose complete control over the
machine and the chain.
12 HOW TO START - USE - STOP THE ENGINE
EN
6. HOW TO START - USE - STOP THE ENGINE
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga SPR 255 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga SPR 255 in the language / languages: All languages as an attachment in your email.

The manual is 9,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info