Manual Stiga READY (page 19 of 36) (English, German, Dutch, French)

608633

Zoom out

Zoom in

1/36

ENGLISH

If the cables are disconnected/connect-

ed in the wrong order, there is a risk of

a short-circuit and damage to the bat-

tery.

If the cables are interchanged, the gen-

erator and the battery will be damaged.

Tighten the cables securely. Loose ca-

bles can cause a fire.

The engine must never be driven with

the battery disconnected. There is a risk

of serious damage to the generator and

the electrical system.

5.8.4 Cleaning

If the battery terminals are coated with oxide, they

should be cleaned. Clean the battery terminals with

a wire brush and lubricate them with terminal

grease.

5.9 Air filter

The pre-filter (foam filter) must be cleaned/re-

placed after 25 hours of operation.

The air filter (paper filter) must be cleaned/re-

placed after 100 hours of operation.

NOTE! The filters should be cleaned/replaced

more often if the machine operates on dusty

ground.

Remove/install the air filters as follows.

1. Clean carefully around the air filter cover.

2. Dismantle the air filter cover (12:R) by remov-

ing the two clamps.

3. Dismantle the filter assembly (12:S). The pre-

filter is placed over the air filter. Make sure that

no dirt gets into the carburettor. Clean the air fil-

ter housing.

4. Clean the paper filter by tapping it gently

against a flat surface. If the filter is very dirty,

replace it.

5. Clean the pre-filter. If the filter is very dirty, re-

place it.

6. Assemble in the reverse order.

Compressed air or petroleum-based solvents such

as kerosene may not be used for cleaning the paper

filter insert. This will damage the filter.

Do not use compressed air for cleaning the paper

filter insert. The paper filter insert must not be

oiled.

5.10 Spark plug

The spark plug(s) must be replaced every 200

hours of operation (=at every other basic service).

Use the spark plug key supplied.

Before disconnecting the spark plug, clean around

its mounting.

Spark plug: Champion RC12YC or equivalent..

Electrode distance

: 0.75 mm.

5.11 Air intake (7:P)

The engine is air-cooled. A blocked cooling sys-

tem can damage the engine. Clean the engine’s air

intake after 50 hours of operation. More meticu-

lous cleaning of the cooling system is carried out

during each basic service.

5.12 Lubrication

All lubrication points in accordance with the table

below must be lubricated every 25 hours of opera-

tion as well as after every wash.

5.13 Fuses

If any of the faults listed below occurs, replace the

relevant fuse. The fuse(s) is located together with

the battery under the engine casing.

6 PATENT - DESIGN REGISTRA-

TION

This machine or parts thereof is covered by the fol-

lowing patent and design registration:

9900627-2 (SE), SE00/00250 (PCT), 9901091-0

(SE), SE00/00577 (PCT), 9901730-3 (SE), SE00/

00895 (PCT), 9401745-6 (SE), SE95/00525

(PCT), 595 7497 (US), 95920332.4 (EPC).

99 1095 (SE), 499 11 740.9 (DE), M1990 000734

(IT), 577 251-253 (FR), 115325 (US).

GGP reserves the right to make alterations to the

product without prior notification.

Object Action Figure

Rear shaft 3 grease nipples. (26:Z)

Use a grease gun filled with

universal grease. Pump until

the grease emerges.

Steering

cables

Brush the cables clean with a

wire brush.

Lubricate with universal

chain spray.

Tensioning

arms

Lubricate the bearing points

with an oil can when each

control is activated.

Ideally carried out by two

people.

Control

cables

Lubricate the cable ends with

an oil can when each control

is activated.

Must be carried out by two

people.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiga READY in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,9 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga READY

Stiga READY User Manual - English - 8 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stiga READY Manual

Product: