575793
15
Zoom out
Zoom in
Previous page
1/16
Next page
ENGLISH
GB
Comfort-President-Royal:
Lubricate the steering chain with chain spray a
couple of times per season.
Pro16-Pro20:
Lubricate the steering chains with chain spray a
couple of times per season. If the steering chains
are really dirty, dismantle them, wash them and
then grease them once more.
Comfort-President-Royal:
The front wheel hub has grease nipples that should
be lubricated after every 50 hours of operation (fig.
24).
Apply universal grease to all the plastic bearings a
couple of times per season.
Apply a coating of engine oil to the tension arm
joints a couple of times each season.
Apply a few drops of engine oil to both ends of the
throttle control cables a couple of times a season.
The hydrostatic transmission is filled with oil
(10W-40) on delivery from the factory. Unless it is
opened (only to be performed by a specialist), and
provided no leakage occurs, no topping up with oil
should normally be carried out. Transmission oil
does not normally need to be changed.
STEERING CABLES
(President - Comfort - Royal)
The steering cables should be adjusted for the first
time after the machine has been in operation for 2
- 3 hours, and then after every 25 hours of opera-
tion.
Put the machine in the straight-ahead position.
Tension the steering cables by tightening the nuts
that are located on the underside of the articulated
steering joint (fig. 21). The screws in the ends of
the cables should be held firmly during adjustment
so that the cables are not twisted. Use an adjustable
wrench or similar for this purpose, inserting it in
the key handles in the ends of the screws. Tension
until all play is removed.
Adjust both the nuts the same amount to ensure
that the alignment of the steering wheel is not
changed.
Once the adjustment is complete, turn the steering
wheel as far as it will go in either direction. Check
that the chain does not come into contact with the
pulley, and that the cables do not become entan-
gled with the steering pinions.
Do not tension the steering cables too hard. Other-
wise the steering will be heavy and wear and tear
on the cables will increase.
STEERING CHAINS (Pro16 - Pro20)
The steering chains should be adjusted for the first
time after the machine has been in operation for 2
- 3 hours, and then after every 50 hours of opera-
tion.
Put the machine in the straight-ahead position.
Tension the steering chains by tightening up the
nuts that are located on the underside of the articu-
lated steering joint (fig. 21). Tension until all play
is removed.
Adjust both the nuts the same amount to ensure
that the alignment of the steering wheel is not
changed.
Do not over-tighten the steering chains. This will
cause the steering to become heavy and will in-
crease wear on the steering chains.
PATENT - DESIGN
REGISTRATION
This machine or parts thereof is covered by the fol-
lowing patent and design registration:
9900627-2 (SE), SE00/00250 (PCT), 9901091-0
(SE), SE00/00577 (PCT), 9901730-3 (SE), SE00/
00895 (PCT), 9401745-6 (SE), SE95/00525
(PCT), 595 7497 (US), 95920332.4 (EPC).
99 1095 (SE), 499 11 740.9 (DE), M1990 000734
(IT), 577 251-253 (FR), 115325 (US).
GGP reserves the right to make alterations to the product
without prior notification.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga PARK PRO 20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga PARK PRO 20 in the language / languages: English as an attachment in your email.

The manual is 3,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga PARK PRO 20

Stiga PARK PRO 20 User Manual - Dutch - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info