608685
12
Zoom out
Zoom in
Previous page
1/18
Next page
64
ENGLISH
EN
4 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.
4.1 Refuelling
Only use diesel which satisfies the minimum re-
quirements of the following specifications:
EN 590
BS 2869 A1 / A2
ASTM D 975 - 1D / 2D
The engine must not be run on rape die-
sel (RME). Contact the engine supplier
for additional information.
1. Open the engine casing.
2. Open the fuel cap (9:X).
Filling fuel above the “Max” level in fig.
9 results in fuel leakage and risk of fire.
3. Fill with diesel to the “Max” level in fig. 9. If
filled above this level the fuel will leak out be-
cause it expands when heated.
4. Close the fuel cap.
Use winter fuel or add kerosene in ambient tem-
peratures below 0°C. See the table below:
Diesel is highly flammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with fuel outdoors,
and never smoke when filling or top-
ping up. Fill with fuel before starting
the engine.
Never remove the fuel cap or fill with
fuel while the engine is running or still
warm.
4.2 Bleeding
The engine’s fuel system must be bled in the fol-
lowing instances:
If the fuel tank has been run dry and air has been
drawn into the fuel system.
After replacing the filter.
Bleed as follows:
1. Fill the tank with fuel.
2. Pump using the hand pump (10:Y) until all air
has been pumped out.
4.3 Level check, engine oil
On delivery, the crankcase is filled with SAE 10W-
40 oil.
Always check the oil level before use to ensure it
is correct. The machine should be standing on
level ground.
Check the oil level as follows:
1. Wipe around the dipstick.
2. Unscrew and pull the dipstick up.
3. Wipe the dipstick.
4. Slide the dipstick down completely and pull up
again.
5. Read off the oil level. The oil level should be at
the “Max” mark as illustrated in fig. 11.
If the oil level is below the “Max” mark in fig. 11,
fill with oil as follows:
1. Unscrew the oil filler cap (11:C).
2. Fill with the necessary amount of oil. Applica-
ble oil types, see “5.4”.
3. Check the level as above.
4. When the level is correct, reinstall the oil filler
cap and tighten.
The oil level must never exceed the “Max” mark as
illustrated in fig. 11. This can cause the engine to
overheat. Drain the oil to the correct level if the oil
level exceeds the “Max” mark.
4.4 Level check, transmission oil
See 5.8.1.
4.5 Safety checks
Check that the results of the safety checks below
are achieved when testing the machine in question.
The safety checks must always be car-
ried out every time before use.
If any of the results below is not
achieved, the machine must not be
used! Take the machine to a service
workshop for repair.
Lowest ambi-
ent tempera-
ture at start °C
Proportion of kerosene
Summer fuel Winter fuel
0 to -10 20% -
-10 to -15 30% -
-15 to -20 50% 20%
-20 to -30 - 50%
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga PARK DIESEL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga PARK DIESEL in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info