608686
17
Zoom out
Zoom in
Previous page
1/18
Next page
69
ENGLISH
EN
5.11.2 Charging using battery charger
When charging using a battery charger, a battery
charger with constant voltage must be used.
Contact your dealer to purchase a battery charger
with constant voltage.
The battery can be damaged if a standard type
battery charger is used.
5.11.3 Removal/Installation
The battery is placed under the engine casing. Dur-
ing removal/installation, the following applies re-
garding connection of the cables:
During removal. First disconnect the black ca-
ble from the battery’s negative terminal (-).
Then disconnect the red cable from the battery’s
positive terminal (-).
During installation. First connect the red cable
to the battery’s positive terminal (+). Then con-
nect the black cable to the battery’s negative ter-
minal (-).
If the cables are disconnected/connect-
ed in the wrong order, there is a risk of
a short-circuit and damage to the bat-
tery.
If the cables are interchanged, the gen-
erator and the battery will be damaged.
Tighten the cables securely. Loose ca-
bles can cause a fire.
The engine must never be driven with
the battery disconnected. There is a risk
of serious damage to the generator and
the electrical system.
5.11.4 Cleaning
If the battery terminals are coated with oxide, they
should be cleaned. Clean the battery terminals with
a wire brush and lubricate them with terminal
grease.
5.12 Air filter, engine
A damaged air filter allows contaminat-
ed air into the engine. This will cause se-
rious damage to the engine.
The air filter must be cleaned after every 50 hours
of operation. The oil filter must be replaced as nec-
essary, or after every 500 hours of operation.
NOTE! Clean/replace the filter more often if the
machine operates in dusty conditions.
Remove/install the air filters as follows.
1. Disconnect the splash guard (23:G) by remov-
ing the nuts (23:K).
2. Clean carefully around the air filter housing.
3. Disconnect the air filter housing by slackening
off the wing nut (23:H).
4. Remove the filter (24:I) by slackening off the
ridged nut (24:J).
Never direct the flow of compressed air
towards the body. The penetration of
air into the blood stream can be fatal.
5. Clean off any dry dirt on the filter by blowing
compressed air in and out of the filter. The pres-
sure must not exceed 5 bar.
Check for cracks or other damage after clean-
ing. This can be visually checked against a light
source.
Check that the filters mating surfaces are free
of faults.
If the filter is damaged, it must be replaced.
If the filter is contaminated by moisture/oily
dirt, it must be replaced.
6. Assemble in reverse order.
Do not use compressed air or petroleum based sol-
vents such as kerosene to clean the paper filter in-
sert. This will damage the filter.
5.13 Air intake
See 10:W. The engine is air-cooled. A blocked
cooling system can damage the engine. Clean the
engine’s air intake after 50 hours of operation.
More meticulous cleaning of the cooling system is
carried out during each basic service.
5.14 Lubrication
All lubrication points in accordance with the table
below must be lubricated every 50 hours of opera-
tion as well as after every wash.
Object Action Fig-
ure
Wheel bear-
ing
2 grease nipples.
Use a grease gun filled with
universal grease. Pump until
the grease emerges.
25
Centre point 4 grease nipples.
Use a grease gun filled with
universal grease. Pump until
the grease emerges.
26
Steering
chains
Brush the chains clean with a
wire brush.
Lubricate with universal
chain spray.
-
Tensioning
arms
Lubricate the bearing points
with an oil can when each
control is activated.
Ideally carried out by two
people.
27
Control
cables
Lubricate the cable ends with
an oil can when each control
is activated.
Must be carried out by two
people.
28
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga PARK DIESEL 4WD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga PARK DIESEL 4WD in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info