10
their screws (4) and (2).
Charge the battery following the battery manufacturer’s
instructions.
To prevent the safety device in the elec-
tronics card from cutting in, never start the engine until the
battery is fully charged!
Follow the battery manufacturer's
instructions regarding safe handling and disposal.
3.3 FITTING THE STEERING WHEEL
Put the machine on a flat
surface and straighten up
the front wheels.
Fit the steering wheel (1)
onto the protruding shaft
(2) with the spokes direct-
ed towards the seat.
Line up the hole in the
steering wheel hub with
the hole in the shaft and
insert the pin supplied (3).
Push the pin in using a hammer, ensuring that it comes com-
pletely through to the opposite side.
WARNING!
IMPORTANT
To avoid damaging the steering wheel
with the hammer, use an awl or a screw-driver of the same
size as the pin to push it in the last part.
3.4 FITTING
THE SEAT
Fit the seat (1) onto
the plate (2) using
the screws (3).
3.5 FITTING THE GRASS-CATCHER
First of all assemble the frame, joining the upper part (1),
including the opening, to the lower part (2), using the supplied
nuts and screws (3) and following the indicated sequence.
Position the angle supports (4) and (5), respecting the right
(R ) and left (L ) sides, and attach them to the frame using
the four self-tapping screws (6).
Insert this frame into the canvas cover, ensuring that it is cor-
rectly positioned along the base perimeter.
Hook all the plastic profiles to the frame tubes with the help of
a screwdriver (7).
NOTE
EN
