Manual Stiga ESTATE 3084 H (page 64 of 118) (English, German, Dutch, French, Italian)

608479

64

Zoom out

Zoom in

Previous page

1/118

Next page

6

2.3 SAFETY REQUIREMENTS

Your machine should be used with due care and

attention. Therefore, labels have been placed

on the machine to remind you pictorially of the

main precautions to take during use. These

labels are to be considered an integral part of

the machine. If a label should fall o or become

illegible, contact your Retailer to replace it. Their

meaning is explained below.

31. Warning: Read the instructions before op-

erating the machine.

32. Warning: Disconnect the key and read the

instructions before carrying out any mainte-

nance or repair work.

33. Danger! Ejected objects: Do not operate

without either the rear discharge guard or

the grass catcher being in place.

34. Danger! Ejected objects: Keep bystand-

ers away.

35. Danger! Machine rollover: Do not use this

machine on slopes greater than 10°.

36. Danger! Dismemberment: Make sure that

children stay clear of the machine all the

time when engine is running.

37. Danger of cutting yourself. Cutting

means in motion. Do not put hands or feet

near or under the opening of the cutting

means housing.

38. Warning! Keep away from hot surfaces.

2.4 REGULATIONS FOR TOWING

A kit for towing a small trailer is available on re-

quest. This attachment must be tted following

the instructions provided.

41. When using the towing kit, do not exceed

the recommended loads stated on the label

and follow the safety instructions.

NOTE The images corresponding to the texts

in chapters 3 et seq., can be found on pages iii et

seq. of this manual.

3. UNPACKING AND ASSEMBLY

For storage and transport purposes, some com-

ponents of the machine are not installed in the

factory and have to be assembled after unpack-

ing. Follow the instructions below.

IMPORTANT The machine is supplied without

engine oil or fuel. Before starting up the engine,

fill with oil and fuel following the instructions given

in the engine manual.

WARNING! Unpacking and completing

the assembly should be done on a flat and

stable surface, with enough space for mov-

ing the machine and its packaging, always

making use of suitable equipment.

3.1 UNPACKING

When unpacking the machine, take care to

gather all individual parts and ttings, and do

not damage the cutting-means assembly when

taking the machine o the pallet.

The packaging contains:

– the machine;

– the steering wheel;

– dashboard cover;

– the seat;

– the front bumper

(if not preassembled in factory);

– the battery;

– the grass catcher (with instructions);

– the lower part of the rear plate, the grass

catcher brackets and attachments necessary

for completing and assembly;

– an envelope containing:

– the instruction manuals and documents,

steering wheel assembly parts and seat as-

sembly bolts and screws

– the connection screws for the battery

cables

– 2 starter keys,

– 1 spare 10 A fuse.

NOTE To avoid damaging the cutting-means

assembly when getting the machine down from

the pallet, take it to the maximum height and be

very careful.

Hydrostatic transmission

– To make it easier to get the machine o

the pallet and to move it, the rear drive

disengage lever should be put in position

«B» (see 4.33).

Disposal of the packaging should be done in ac-

cordance with the local regulations in force.

3.2 FITTING THE STEERING WHEEL

• Steering wheel Type “I” (Fig. 3.1)

Put the machine on a at surface and straighten

the front wheels.

Mount the hub (1) on the shaft (2), making sure

that the plug (3) is correctly tted into the hub

seat.

Fit the dashboard cover (4) clicking the seven

fasteners into place.

Fit the steering wheel (5) onto the hub (1) with

1

the mower wont go into mowing drive when I lift the button
Submitted on 7-3-2023 at 06:09
Reply Report abuse
The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10
Reply Report abuse
I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47
Reply Report abuse
my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
Dave Submitted on 8-12-2018 at 20:29
Reply Report abuse
HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
Thank you in advance Submitted on 2-7-2018 at 08:44
Reply Report abuse
How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Register

Register getting emails for Stiga ESTATE 3084 H at:

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info