608479
31
Zoom out
Zoom in
Previous page
1/118
Next page
15
erbe alte e selvatiche (trifoglio. margherite. 
ecc.).
2.  È sempre preferibile tagliare l’erba con il 
prato ben asciutto.
3. I dispositivi di taglio devono essere integri e
ben alati, in modo che la recisione sia netta 
e senza sfrangiature che portano ad un in-
giallimento delle punte.
4.  Il motore deve essere utilizzato al massimo 
dei giri, sia per assicurare un taglio netto
dell’erba che per ottenere una buona spinta
dell’erba tagliata attraverso il canale d’espul-
sione.
5.  La frequenza delle rasature deve essere rap-
portata alla crescita dell’erba, evitando che
tra un taglio e l’altro l’erba cresca troppo.
6.  Nei periodi più caldi e secchi è opportuno 
tenere l’erba leggermente più alta, per ridurre 
il disseccamento del terreno.
7.  L’altezza ottimale dell’erba di un prato ben 
curato è di circa 4-5 cm e, con un solo taglio, 
non bisognerebbe asportare più di un terzo
dell’altezza totale. Se l’erba è molto alta è 
meglio eseguire il taglio in due passate, a di-
stanza di un giorno; la prima con i dispositivi 
di taglio ad altezza massima ed eventual-
mente a scia ridotta,  e la seconda all’altezza 
desiderata (Fig. 5.14).
8.  Laspetto del prato sarà migliore se i tagli 
saranno eseguiti alternandoli nelle due dire-
zioni (Fig. 5.15).
9.  Se il convogliatore tende ad intasarsi d’erba 
è bene ridurre la velocità di avanzamento 
in quanto può essere eccessiva in funzione 
della condizione del prato; se il problema 
rimane, cause probabili sono i dispositivi 
di taglio male alati o il prolo delle alette 
deformato.
10.  Fare molta attenzione ai tagli in corrispon-
denza di cespugli e in prossimità di cordoli 
bassi che potrebbero danneggiare il paral-
lelismo e il bordo dellassieme dispositivi di 
taglio ed i dispositivi di taglio.
6. MANUTENZIONE
6.1 RACCOMANDAZIONI
PER LA SICUREZZA
ATTENZIONE! Occorre contattare
immediatamente il vostro Rivenditore o un
Centro specializzato qualora si riscontras-
sero irregolarità nel funzionamento
del freno,
dell’innesto e arresto dei dispositivi di
taglio,
dell’inserimento della trazione in marcia
avanti o retromarcia.
6.2 MANUTENZIONE ORDINARIA
La tabella ha lo scopo di aiutarvi a mantenere 
in ecienza e sicurezza la vostra macchina. In 
essa sono richiamati i principali interventi e la 
periodicità prevista per ciascuno di essi.
Le caselle a anco vi permettono di annotare la 
data o il numero di ore di funzionamento nelle 
quali l’intervento è stato eseguito.
Intervento Ore Eseguito (Data o Ore)
1. MACCHINA
1.1
Controllo ssaggio e alatura dispositivi di
taglio
3)
25
1.2
Sostituzione dispositivi di taglio
3)
100
1.3
Controllo cinghia trasmissione 
3)
25
1.4
Sostituzione cinghia trasmissione
2) 3)
1.5
Controllo cinghia comando dispositivi di taglio
3)
25
1.6
Sostituzione cinghia comando dispositivi di
taglio
2)  3)
1.7
Controllo e registrazione freno
3)
25
1.8
Controllo e registrazione trazione
3)
25
1.9
Controllo innesto e freno dispositivo di taglio
3)
25
31


Need help? Post your question in this forum.

Forumrules
1

Forum

stiga-estate-3084-h

Reset search

  • the mower wont go into mowing drive when I lift the button
    Submitted on 7-3-2023 at 06:09

    Reply Report abuse
  • The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10

    Reply Report abuse
  • I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47

    Reply Report abuse
  • my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
    Dave Submitted on 8-12-2018 at 20:29

    Reply Report abuse
  • HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
    Thank you in advance Submitted on 2-7-2018 at 08:44

    Reply Report abuse
  • How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga ESTATE 3084 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info