608479
23
Zoom out
Zoom in
Previous page
1/118
Next page
7
della macchina e degli imballi, avvalendosi
sempre degli attrezzi appropriati.
3.1 SBALLAGGIO
Allatto della rimozione dell’imballo, fare atten-
zione a non perdere tutti i singoli particolari e
le dotazioni, e a non danneggiare l’assieme di-
spositivi di taglio al momento della discesa della 
macchina dal pallet di base.
L’imballo contiene:
–  la macchina vera e propria;
–  il volante;
–  la copertura del cruscotto;
–  il sedile;
–  il paraurti anteriore (se non premontato in 
Fabbrica);
–  la batteria;
–  il sacco (con le relative istruzioni);
la parte inferiore della piastra posteriore, i
supporti del sacco e i relativi accessori di
completamento e di montaggio;
–  una busta con:
–  i manuali d’istruzioni e i documenti,
–  i componenti di montaggio del volante e la 
viteria di montaggio del sedile,
–  la viteria di collegamento dei cavi della 
batteria,
–  2 chiavi d’avviamento, 
–  1 fusibile di ricambio da 10 A.
NOTA Per evitare di danneggiare l’assieme
dispositivi di taglio, portarlo alla massima altezza
e prestare la massima attenzione al momento
della discesa dal pallet di base.
Trasmissione idrostatica
Per agevolare la discesa dal pallet e lo
spostamento della macchina, portare la 
leva di sblocco della trasmissione poste-
riore in pos. «B» (vedi 4.33).
Lo smaltimento degli imballi deve avvenire se-
condo le disposizioni locali vigenti.
3.2 MONTAGGIO DEL VOLANTE
Volante Tipo “I” (Fig. 3.1)
Disporre la macchina in piano ed allineare le 
ruote anteriori.
Montare il mozzo (1) sullalbero (2), avendo cura 
che la spina (3) sia correttamente inserita nella 
sede del mozzo.
Applicare la copertura del cruscotto (4) inse-
rendo a scatto i sette agganci nelle rispettive
sedi.
Montare il volante (5) sul mozzo (1) in modo che 
le razze risultino rivolte verso il sedile.
Introdurre il distanziale (6) e ssare il volante 
tramite la viteria (7) in dotazione, nella se-
quenza indicata.
Applicare la copertura del volante (8) inserendo 
a scatto i tre agganci nelle rispettive sedi
Volante Tipo “II” (Fig. 3.2)
Disporre la macchina in piano ed allineare le 
ruote anteriori.
Montare il mozzo (1) sullalbero (2), avendo cura 
che la spina (3) sia correttamente inserita nella 
sede del mozzo.
Applicare la copertura del cruscotto (4) inse-
rendo a scatto i sette agganci nelle rispettive
sedi.
Montare il volante (5) sul mozzo (1) in modo che 
le razze risultino orientate correttamente.
3.3 MONTAGGIO DEL SEDILE (Fig. 3.3)
Montare il sedile (1) sulla piastra (2) utilizzando 
le viti (3).
3.4 MONTAGGIO E COLLEGAMENTO
BATTERIA (Fig. 3.4)
La batteria (1) è alloggiata sotto il sedile, tratte-
nuta da una molla (2).
Collegare prima il cavo rosso (3) al polo positivo 
(+) e successivamente il cavo nero (4) al polo 
negativo (–), utilizzando le viti in dotazione come 
indicato.
Spalmare i morsetti con del grasso siliconico e 
curare il corretto posizionamento del cappuccio 
di protezione del cavo rosso (5). 
IMPORTANTE Provvedere sempre alla com-
pleta ricarica, seguendo le indicazioni contenute
nel libretto della batteria.
IMPORTANTE Per evitare l’intervento della
protezione della scheda elettronica, evitare
assolutamente di avviare il motore prima della
completa ricarica!
3.5 MONTAGGIO DEL PARAURTI
ANTERIORE (se previsto)
Paraurti Tipo “I” (Fig. 3.5)
Montare il paraurti anteriore (1) sulla parte infe-
riore del telaio (2) utilizzando le quattro viti (3).
23


Need help? Post your question in this forum.

Forumrules
1

Forum

stiga-estate-3084-h

Reset search

  • the mower wont go into mowing drive when I lift the button
    Submitted on 7-3-2023 at 06:09

    Reply Report abuse
  • The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10

    Reply Report abuse
  • I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47

    Reply Report abuse
  • my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
    Dave Submitted on 8-12-2018 at 20:29

    Reply Report abuse
  • HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
    Thank you in advance Submitted on 2-7-2018 at 08:44

    Reply Report abuse
  • How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga ESTATE 3084 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info