564042
111
Zoom out
Zoom in
Previous page
1/788
Next page
53
User’s manual
EN
Problem
Cause
Remedies
“Sync error” appears
on the display
The robot’s receiver
does not recognise
the signal
Turn the robot off and then turn it back on
again. If the problem persists, contact your
nearest authorised service centre
“Too high grass” or
“Blade Error” appe-
ars on the display
Cutting blade da-
maged
Replace the blade with a new one
(see “Blade Replacement”)
Cutting blade fouled
(tape, cords, plastic
fragments, etc.)
Stop the robot safely
(see “Robot Safety Stop”)
Use protective gloves to prevent injury.
Unclog the blade
The robot was
started too close to
obstacles (less than
a distance of m) or
in the presence of
obstacles (fallen
branches, forgotten
objects, etc.)
Stop the robot safely
(see “Robot Safety Stop”)
Remove the obstacles and restart the robot
(see “Start-up and manual stopping of the
robot (in closed areas)”)
Electric motor failure
Have the motor replaced or repaired by your
nearest authorised service centre
Too high grass
Increase the cutting height (see “Adjustment
of cutting height”)
Carry out a preliminary cutting of the area
with a normal lawnmower
The remote control
does not work
Programming error
Correctly program the remote control
(see “Programming Mode”)
The LED of the remo-
te control does not
light up
Remove the batteries and replace them
(see “Replacement of remote control batteries”)
Warning - Caution
111


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga AUTOCLIP 720 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga AUTOCLIP 720 S in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 96,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info