564042

Stiga AUTOCLIP 720 S Manual

74
Zoom out
Zoom in
Previous page
1/788
Next page
16
User’s manual
EN
PLANNING OF PLANT INSTALLATION
The robot is not dif cult to install, but requires some preliminary planning in order to de ne the
best area for installing the charging station, the power supply-transmitter unit and for tracing the
path of the perimeter wire.
INSTALLATION AREA OF THE CHARGING STATION AND POWER SUPPLY-TRANSMITTER UNIT
• The charging station must be positioned on
the edge of the lawn, preferably in the lar-
gest area where other areas of the lawn are
easily accessible. The area with the char-
ging station is hereinafter referred to as the
“Primary Area.”
Min. height. 160 cm
/ 63 inc.
Min. width
200 cm
/ 78,74 inc.
Power supply-transmitter unit
perimeter wire
charging station
Position the power supply-transmitter
unit in an area that cannot be accessed
by children. For example, at a height
above 160 cm (63 in.)
Warning - Caution
When connecting the electricity, make sure there is a power outlet near the
installation area. Make sure the connection to the mains power conforms to the
applicable laws. To operate in complete safety, make sure the electrical system,
which is connected to the power supply-transmitter unit, is equipped with a
well-functioning earth system.
Important
It is advisable to install the unit in a cabinet for electric components (for outdoor
or indoor use) that is well-ventilated to maintain a correct air circulation and
equipped with a key lock.
Warning - Caution
Make sure access to the power supply-transmitter unit is allowed only to
authorised people.
• Operation of the robot. The robot must be able to easily  nd the charging station at the
end of the work cycle, which will also be the departure point for a new work cycle and for
reaching any other work areas (hereinafter referred to as the “Secondary Areas”).
• Position the charging station according to these rules :
- On level ground
- On compact and stable ground with good drainage
- Preferably in the largest area of the lawn
- In case of sprinklers, make sure the water jets are not directed inside the charging station.
- Make sure the entrance of the charging station is positioned as shown in the  gure so that
the robot can enter it by following the perimeter wire in a clockwise direction.
Warning - Caution
… 74 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga AUTOCLIP 720 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga AUTOCLIP 720 S in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 96,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info